Find a professional heating and cooling technician in North Brisbane

wall mounted Haier split system air conditioner needs service

Fault identification performed on indoor Mitsubishi Electric air conditioner. Requires 2 replacement PCBs. Parts can be obtained

2 air conditioning units need to be disconnected for concreting and reinstalled when finished. Gasto be retained in each unit.

Daiken air conditioner (likely around 7 years old). Blowing cold air but isn’t very strong, have tried changing settings on remote. Connected to an outdoor unit alongside 2 other air conditioners. Other two are working fine so likely not related to issues with the outdoor unit.

Hi, I’d like to get a quote please. I need: 1️⃣ A full clean/service for two air-conditioners (one Samsung and one TCL) 2️⃣ The Samsung unit is leaking water when it’s running, so it needs to be checked/fixed Could you please let me know: • The total cost • Soonest availability • If there are any call-out fees Thank you!

Reinstall and secure 1 round ducted air-conditioning ceiling vent that has come loose. (Need a new piece)

Actron Air ducted 2 zone system is not blowing cold air. No error codes so could possibly be in need of regassing. Looking for someone to diagnose the issue and if it is in need of regassing to carry out those works.

Four air conditioning units need installation. Will pay cash Three 2.5 aircons (one for each bedroom) One 7.5 aircon for living area

remove old split system and install new one

Daikin airconditioner ARC433A21 has a leak. Pls see attached pictures

Neatly reroute two air conditioner condensation drain pipes so they run flush against the wall. Use appropriate piping, clamps, and fixings to secure the lines, and connect them into the nearest existing downpipes. Work is to be completed in a tidy, professional manner. Refer pictures.

I need a qualified AC technician to repair my broken aircon. Error code 01 EL. See photo for the AC specifications. Thanks

Looking for a qualified technician to deep clean 7 split system air conditioners. 3 of 7 units have visible mould, so mould treatment will be required where necessary. Preferred date is January 8, however timing is flexible. Please advise experience, inclusions, and availability. Please let me know price and I will sort in full after job is done. Thank you!

I have a ducted air conditioning unit that is due for a service. Price negotiable. I just put in $100 cause it demanded a number.

I have 2 split system air conditioning units that require replacement. These will be installed in the same location as the existing units. The dwelling is a 2 story townhouse, with external units mounted to external wall - not ground (replacement in same location as existing to comply with BC). I will supply the units (a 2.5kw Panasonic for primary bedroom, and a 3.5kw Panasonic for downstairs living room). I am looking for a quote for the installation, with job completion before mid Jan.

Four switch board need replacing, fix two air conditioners, change light fitting.

I can drive to you if you need. I'm almost 100% sure there's no leak, just needs a regas

Please find attached picture. Back side of aircon came off which needs to be replaced. Please suggest me a better solution to this.

Our split system air conditioner has broken down and so we need a new air conditioner, which you can supply if you want or I can get one by tomorrow and we need it installed tomorrow as we have people coming to our place for Christmas Day. We are replacing an average sized lounge room air con. WE ARE REPLACING A PANASONIC HEATER/COOLER CS-A24BKP. Ignore price

Hi there, I’m looking for a licensed air conditioning installer to replace my existing Haier AS53TD1HRA (5.3 kW split system) with a Westinghouse WSD73HWA (7.3 kW split system). Below are the details: ⸻ Existing Unit (Haier AS53TD1HRA) • Type: Split system (reverse cycle) • Cooling capacity: 5.3 kW • Heating capacity: 5.6 kW • Indoor unit size: 1008 mm (W) × 318 mm (H) × 225 mm (D) • Outdoor unit size: 890 mm (W) × 697 mm (H) × 353 mm (D) ⸻ New Unit (Westinghouse WSD73HWA) • Type: Split system (reverse cycle) • Cooling capacity: 7.3 kW • Heating capacity: 7.8 kW • Indoor unit size: 1196 mm (W) × 370 mm (H) × 279 mm (D) • Outdoor unit size: 890 mm (W) × 673 mm (H) × 342 mm (D) ⸻ Work Required • Remove existing Haier unit • Install new Westinghouse system (including mounting, refrigerant line, drainage, and electrical connection) • Check refrigerant pressure and vacuum • Provide installation certificate and compliance documentation ⸻ Requirements Installer must hold: • A valid Refrigerant Handling Licence • A valid Electrical Contractor Licence (or work with a licensed electrician)