Find professional metal gate repairs in VIC

I have 3 outdoor metal gates (1 front entrance gate and 2 side gates) that need adjustment. They were all working fine before, but due to minor alignment shifts over time, they’re no longer closing properly. All hinge are same type as pictured. The front gate is now very tight and difficult to operate. The two side gates aren’t closing or latching properly. Looking for someone experienced who can realign and adjust the gates so they open and close smoothly again.

Move and replace metal hinges (3) to allow gates to close . Add vertical bolt

Repair and paint metals gates

Metal gate no longer closes. It hits the upright.

Metal Gate fixing loose - need to permanently secure the fixing as attached. Tack Weld the screw/washers to the metal post Minor Alignment of gate

i have a colourbond gate that needs to be fix the bottom bit comes lose and the latch is not aligned) (currently was held together with cable tire and stick) the price must incl. all materials and labour location: west Melbourne 3003 (as in cbd)

Take away old cupboard and metal gate. Access via laneway at back of house.

Repair of metal gates and framework between car Portland back hard. One gates metal frame would need to be straightened or rebuilt.

Heavy external gate with metal frame required two new heavy duty hinges to be welded on so that gate is reattached. Must be in correct alignment so that gate can be bolted shut as per photos.

Repair hinge on gate. Top hinge just need a Dimond screw.

Repair top hinge on metal gate

Fix metal gate it's hard to shut out if align ment. Western suburbs. One I northern. Gate us wider in the west but just wire gate with metal frame. Tight and must lift a few mm with foot to close very annoying to the elderly

We are repainting our metal front fence. Before we prime and paint, we need all gate framing and panel surfaces prepared, metal brushed/sanded back, surface rust removed/sanded off and existing remaining paint and metals surfaces prepared ready for new primer and paint finish. Gate(s) are approx. 1.7M high x 2.3 M wide overall. Someone with time, correct tools, equipment, knowledge and elbow grease required to complete the job.

Our secure metal gate isn’t so secure. An intruder could reach through and turn the knob. Whoops. Would like a well-rated Handyperson/welder to come and resolve the problem, we think by sourcing a small metal plate and welding it beside the lock, but if there’s a better way of doing it that would solve the problem and look better than that solution please speak up! Photos attached show the problem. Looks like steel to me but you’ll know better than I will.

I need assistance replacing the rotten wood and re-hanging a gate that has collapsed. The wood on each side of the gate that is attached to the fence and the house is completely rotten and needs replacing and re-attaching. The gate will then need to be re-hung and aligned. The gate and each bit of wood that it is attached to are approximately 210cm tall.

Having concrete poured on 6 January in my courtyard and require a new metal back gate and fence to replace the old wooden gate and fence. Total length is 2.5 metres and configuration will be fence - gate - fence. The fence height should be 2.2 metres high. Happy with either slat or colorbond in a monument grey colour, with a lock. Ideally, would like this job done before the concrete is poured or on the day of the concrete pour.

Metal gates with timber panels is sagging. Needs to be fixed. Right side panel is sagging and hits the left gate on the top.

Fix / repair gate that does not close properly. Gate is rubbing against hanging poles and will not close properly. Needs to be repaired or rehung.

Hinges have seized up and latch has broken on side metal garden gate. I will need hinges and latch to be provided.

Hello, one side of my gate has broken hinge. Needs repair. Photo attached of the issue and the gate