Find a professional gate installation in Darwin

Existing chain link gate is 2600mm wide and is double opening on hinges. Want the gate to be made wider by 1000mm. Job/quote to include * relocation of fence post on one side of gate by 1m - fence to be properly finished to post in new location * supply & install new double swing gate * reuse of existing hardware where possible (hinges/latch) Eventually we want to replace the manual double swing gate with an motorised/electric single rolling gate, so this is an interim solution - we are looking for the lowest cost to make the gate wider with similar level of functionality/quality as the current gate

I need a lock installed in my gate for safety purpose.

I want to install a lock in my outside gate for security purpose.

Gate installation for security

We need to create an enclosed area for our chickens and add some protection over the existing coop. Here’s what’s required: 1. Build Two Mesh Fences * Construct two mesh fences, approximately 2m by 3m each to enclose a section between two existing stable fences. * The mesh fences will need to connect to a central support post for stability and to serve as the joining point * One of the mesh fences should include a small gate to allow easy access to the coop. 2. Add Mesh Water Protection * Install mesh cover over the small chicken coop we already have, to provide some water protection (e.g. from rain). Needs to be secure but allow airflow. Materials: - All materials (mesh, poles, gate hardware, etc.) will need to be sourced from Bunnings or a similar supplier. - Please keep all receipts — we will fully reimburse the cost of materials.

I need pool fencing installed in two small areas for pool compliance (AS1926.1–2012). Scope of Work: • Area 1: Install 1 gate + fence panels with posts. • Area 2: Install 1 gate with posts. (-possible area 3 to discuss ) Compliance Requirements: • Fence/gates must be ≥1.2 m high. • Gate(s) must be self-closing, self-latching, swinging away from pool. • Latch release ≥1.5 m high. • Gaps <100 mm under/through fence. • Posts set in concrete footings or securely fixed into solid masonry. • Install must pass NT pool safety inspection. I will provide: • Site access. • Can supply panels/gates/latches from Bunnings. You need to provide: • Tools, fixings, concrete. • Experience with pool fencing installs or compliance work. ⸻ Job Location: Budget: $1000 (labour only, depending on complexity & materials). Please quote. When: ASAP (need compliance before wet season).

The electric door was bent by a car and the wheels deviated from the track

I need a professional to help with my automatic gate in Larrakeyah, Darwin, NT. The gate uses a BFT BT A400 controller and an Ecosol solar power system to run on battery and solar energy. I’ve installed a Remootio 3 remote control device, but it only works if I use another remote first to "wake up" the gate; otherwise, the system goes into sleep mode and doesn’t respond. I need someone to fix this so the Remootio 3 works reliably on its own. Should have experience with automatic gates, solar-powered systems, and remote controls. Please bring tools and be ready to troubleshoot on-site.

A old pool fencing that is bolted into ground that needs to be removed. Over the years the bolts that hold the gate down, require the right tools to do the job. Getting paving done in the area hence the timeframe.

Repair electric solar powered gate

Needing someone who is able to help drill into concrete & install a new gate motor. Already have new motor supplied

Currently have a manual gate that I would like to have automatic solar opener installed. The gate is dual inwards opening.

There are three missing poles on our gate. I will provide the poles, but need someone to bring a welder to reattach them.

Need patio gate fixed. Possible replacement of hinges, and lock.

I have an old spa in the back yard. It had corrugated iron sheeting put around it for aesthetic reasons (!) but now it is old and damaged and a bit dangerous. I need the corrugated iron removed, some rubble - concrete blocks / piping / rubbish around the spa, and the plumbing all removed. And the cage door left and a lock put back on it.

After a recent storm the gate stopped opening - locked & unlocked it but still won’t respond to the beepers. Need someone to fix if possible.

New gate opener to replace old one as it is not working properly.

I bought a Vevor gate opener and would like it replaced by my old gate opener as my manual operation has seized and the gate keeps stopping as well.

My dog is escaping from a gap beneath my driveway gate. Gate needs to be fixed or patched up but still need to open to let car in. - Due date: Before Monday, 11 December 2023

Gate placed back on tracks but can’t get clicker or motor to work - Due date: Before Friday, 20 October 2023