Find a local console repairer in Sydney Eastern Suburbs

I have a metal lampshade skeleton that is slightly oversized for the outer shade. Small, precision adjustment needed — looking for someone to shorten the inner support arms slightly so the frame fits correctly. May involve cutting and re-welding or brazing small sections (open to your recommendation). This is not a full rebuild. Happy to share more photos and exact measurements. Experience with lamp frames, light fittings, or small metal fabrication preferred. Frame is coated — I understand the coating may need minor touch-up at the weld points.

Professional installation of a wall mounted cabinet (primary task) + install 3 simple doorstops + install outdoor decorative hose connection (simple screw in)

Replace wooden garden steps with new steps. Open to suggestions of cost effective solutions for new steps. Remove and dispose of old wooden steps. Existing dimensions in cm: H75 W117 D90 (Height is to the paved area)

My kitchen tap is not working well and need to be replaced with a new one. I bought one from applince Online. My shower taps are too tight.

Change the old kitchen tap to a new one. some other taps are too tight to close.

My car has paint chips on these panels: - quarter passenger side - quarter driver side - bonnet - driver side rear door (And my mirrors are damaged but not as bad, so not critical) I’d like to get a new paint coat on these panels, probably needing to strip back a big section of it first. I am mobile and can drive up to 1h from Kingsford if that helps. Thanks !

Kitchen tap need replaced with the new one which I will buy. Shower taps are very tight so need to be looked at.

My washing machine from kogan (duo washer/dryer) is saying E12 mid wash. We have checked the filter to make sure nothing is stuck but it is still saying it, need someone to help fix the issue

I’m looking for a qualified plumber to replace my shower taps, and also add more plumbing tape to my shower head (it’s a little leaky). Please see pics for current taps. Below is a link to the quarter pins I’m replacing the taps with. https://www.bunnings.com.au/mondella-chrome-resonance-1-4-turn-pin-lever-wall-top-assembly_p0683916

Water filter to be put on tap in kitchen

Need help moving washing machine in box up three flights of stairs and installing in kitchen.

Instal 2.5metre Porta handrail on four brackets with two endcaps. It is a masonry wall.

Drill and secure 2 wheel stops into concrete garage floor . 3 mounting spikes provided should

I’m starting a kitchen and laundry renovation and qualified plumber to cut off water to the existing sinks and taps disconnected. No new fixtures need installing yet — just need everything safely capped and ready for the renovation work. This includes a kitchen and a laundry + reverse osmosis tank system.

Install: 3 Tile Change 4 taps 1 shower 1 faucet in same bath

We have new ikea kitchen and the bench tops are too long and the sink hole needs to be cut in plus a bathroom door rehung

hey closed off previous posting but could use a helper if available tomorrow morning around 9-11ish at bellevue hill. probably half a day and we can work out a rate if you want to stay around with other things if needed. pretty much I need someone who has painting experience to help with a master bedroom ceiling in dulux ceiling white, ideally if you can cut in tidily it would be great as ceiling doesnt have cornices so its not the easiest.

Paint and fill gaps on skirting board in a 2 bedroom apartment. Living room and bedrooms

Need a pair of vintage lamps re wired

The shower head has a leak. I’ve already purchased replacement, so it’s just a matter of getting them installed.