Find trusted amplifier repair experts in VIC

Sony amp no longer getting video signal after swapping HDMI connection and new TV . Also have a back haul mesh network thstbibwiuld line someone to look at .

Two of my speakers at the courtyard not working, need to check and fix

Error message on amplifier NG:LCRSLSRBLBR, have tried a factory reset to no avail. Might need to replaced the two fuses located at rear of amplifier

My amp has stopped giving out sound for some reason. I used to sell amps second hand so I know how to test them, but not fix them. I've had this sitting around for a year now and I have forgotten the specifics of the problem. But it needs fixing.

I have a 2004 ba ford i would like my pioneer amp installed into the factory wiring ive already installed the sub so u can easily run the power and ground wires through 2x3way 4 gauge spliters i have,I have everything needed just the amp needs the installation ive swaped the speakers already thank you

There is an amplifier that needs swapping it’s plug and play with the current amplifier There is also 4 walls speakers that need to be removed and swapped with the new units. The current brackets will need to be removed and the new speaker brackets will need to be fitted 3 out of the 4 speakers will be into brick and one into timber The speakers will also need the wiring connected. Again, this is a LFL system so not complicated You will need a big ladder as they are situated about 3.5m off the ground in a warehouse

My underseat Sub stopped working, was installed at autobahn.bougth another I fitted it but still no sound

I currently have a projector and amplifier installed that I upgraded about 2.5 years ago. I’m wanting to swap them out with the two old units I have as I want to put the upgraded units somewhere else.

Need 2 car amplifier's fixed

Need help diagnosing a problem with a custom 125kHz low-frequency receiver circuit for a university electronics project. The amplifier stage works perfectly (verified with oscilloscope - clean 18V output), but when I connect it to an audio transmitter module (TS832 FPV transmitter), the signal disappears despite using isolation resistors (2kΩ, tried 4kΩ). Components involved: AD8129 differential amplifier (±9V supply) TS832 5.8GHz FPV transmitter (for audio relay) Custom tuned 125kHz antenna Have oscilloscope and all test equipment available. Just need someone experienced with RF/audio circuits to help identify why the transmitter is loading down the amplifier output.

Experience person to put together a springless trampoline

Repair car audio tunex amplifier.

Hi, can you please install my android head unit, amplifier, and speakers for my Honda jazz. Am pretty flexible

I have 2 ceiling speakers with speaker wire that I need to be routed from downstairs living room and one speaker to be routed from upstairs bedroom all the way to the amplifier. 🔊 A licensed handyman or an electrician would be needed to do such as they would need to push or install the wire throughout the cutouts to the amplifier in the ceiling. Total speakers 2 🔊 Total amplifiers 1 Job needed install speakers and route wires to connect Job should be around 2-3 hours but no rush

I need a trampline out together it is a Thunder 2 XL

The AC power not engaging the AMP. Unable to power up the unit

Hi, Alpine amp model MRX-M55 needs repair. It works but cuts out at 50% volume. I was trying to test and tune it, but I must have introduced a dirty signal. It’s definitely an input issue. I opened it up to have a look inside and the PCB, capacitors, resistors, etc all look fine. Thank you.

Marantz amp AV surround receiver SR 5003

Large oval Springfree trampoline

Syrup amplifier to new TV connection with surround sound and please set up PlayStation and anything else that needs to be hooked up