36 Electricians in Newcastle

Yamaha EF2000. Runs with a little fuel dribbled into the cylinder but then, it won't run, like it isn't getting any fuel. Could be a carbie or fuel line issue, don't know. Would like it fixed asap.

Powerpoints, range hood and cooktop need to be wired in.

Hi. Looking for an electrician to check stove top electrical and to install new ceramic cooktop. We recently had an electrical burn we believe from our stove top during the week and trying to organise an electrician to have a look and see what the damage is and what next steps would be for us as well as connect new electrical cook top. To note per the photos that the stove top and oven electrical connected in one electrical junction box. We just want to make sure the over and all other electrical is fine before we put in new cooktop. Cheers, Kim

I need to remove the short legs on the bed and replace them with the longer legs, they screw in.

14 light fittings to be hard wired in large house must be done today.

Need to change some old outdoor lights over to sensor lights. Then hard wire solar gates to them so the gates can work on solar and back up electricity

I have a sensor light at my front door which no longer works. I need this light checked out and replaced if needed. I also need replacement supplied. Budget negotiable (within reason)

I need 3 new fans to be installed. Either bought through electrician or I will purchase them depending on costs.

- New rubber seal for washing machine needs to be installed correctly - all parts ready to go, can bring tools but have some here - model: Electrolux inverter EWF14742

Bathroom -Combined fan/light / heat - Heated towel rail - Power point Kitchen -Remove fluro light - Install new Dow lights x 6 - Install new power points x 3 Upgrade power box We get the house on 24th May, needing someone who is flexible end of may / early june to do the works.

Install of 30 down lights easy access to roof space and removal of old light fittings

We need a new set of hotplates connected to electricity. They are replacing an existing set, the builder has installed the new set, just need it hooked up to the electricity. all electrical components are ready, just need a licensed electric

We are looking for electrician to do some job. Shop signage connection, Few sockets, lighting required and other minor job at Hamilton. We are looking for individual electrician and not companies

Take away old 250L hot water heater tank which has been uninstalled from our backyard. There are two ramps about 5 metres each, about 45 degree incline, to take it up. Tank weighs about 70kg.

Electrician required for installation of heat light in bathroom

I need an additional phone line installed that will be plug in and my nbn modem work (modem is currently in the kitchen working and I need it in another room) PLEASE SEND YOUR OFFER INCLUDING EQUIPTMENT, you must be qualified thanks

We are having our ceiling resurfaced. For the plasterer to work around the light we just need the oyester light removed (including the piece it screws into) and the live wires capped off for safety. Should only take 15 minutes or so I’ve been told. Note- wires need not to be removed. Lights will go back up once completed.

Led spotlights on shop roof at Cardiff

Need a power point put in behind a TV mounted on wall. No power point close by. Power will have to be run up through roof about a 1.5m from power box. Need done asap

phone line wall box/socket fallen from wall and has wiring exposed and not connected resulting in the phone not working.