Find trusted local electricians in Campbelltown

install dining light on top of my dining table - Due date: Flexible

Hi, I need a quote for installation of an external power point. There is Power inside the house close to the place this new power point need to go. Single storey home with tiled roof and brick Vineer home. Campbeltown SA - Due date: Flexible - Due date: Before Saturday, 15 July 2023

Dear Sir/Madam, I have given your contact details as trusted installer for the Beacon lighting. The scope of works include- Dismantling three ceiling fan/ lightings and install the following- 1x FANAWAY VEIL FAN/LT CHR, Supplier code LD-212923 1x DAKOTA 3LT 380mm ES FLUSH CHROME, Supplier code 089918 1x Uno 250mm 1 Light Flush Mount in Grey Fabric, supplier code 080784 with Lucci Connect 16W 200mm GX53 LED Dimmable Globe in RGB+CCT. The existing 3x fan lights (fully functional) can be taken away by the installer free of cost. Must be a licensed Electrician (will need licence details before engagement). - Due date: Flexible

NBN modem is currently installed in Master Bedroom and I would like to move it to the Living room or into a cupboard in Hallway whichever is easier. Moving it into the cupboard will involve installing a electrical point as well.

Hi would like have 2 power outlets installed. Based in Campbelltown Adelaide. Thanks

I need conduit installed in my town house to supply my NBN FTTP installation. Currently there is a Ethernet cable installed from the external wall through both levels of the house to connect the NBN box but the builders of this house cut corners and didn’t install the conduit so we can upgrade the ethernet cable to fibre now that we have it available from service provider. - Due date: Flexible

install a new power socket - Due date: Needs to be done on Thursday, 20 October 2022

3 gang light switch to change to a smart switch. - Due date: Flexible

Approx. 10 downlights installed. Must be qualified electrician. - Due date: Flexible

I need an electrician to install tv antenna and extra lights - Due date: Flexible

The existing switch has 3 button, only change one button to the back of the wall

Hav about 6 down lights and a couple of bathroom heat lamps to repair.

Looking to get a new ceiling light installed. My home is a two-storey with a void overlooking the living area - this is where I need the new light installed. The ceiling is 6m high and the void is 2x3.5m, so access to the ceiling may be tricky (I'm thinking scaffolding may be needed, open to discuss this). There is a light fixture already there, but its really light weight. The new light is about 4kg and the cord length is 1.8m, so I'd also need the cord length made longer. Can provide images if needed and open to negotiate price as I understand this is quite a complex job - Due date: Flexible

Needed certified electrician to install power sockets on the wall. It currently has light switches on it and in backside which is garage it has power plugs. Wall is timber made. Photo attached

Needing someone to wire up a new oven asap.

Note: No rush on time frame. I'm after the bottom 2 gang to be changed to 4. Above that, I want a 2 gang PowerPoint installed. Needs to be a clean install.

I have the brackets for both TVs! For the main TV 65 inch ( for living room) I just require TV to be wall mounted (cords not to be exposed) and connected. The antenna and power point already exist. For the TV (50 inch) in the bedroom, I need an antenna and power point to be installed and then the TV to be wall mounted. (cords not to be exposed). This is a two storey townhouse with manhole upstairs.

We need an electrician to do the cabling/wiring for NBN connection. The house was built in 2018 but it is not NBN ready. We recently had the NBN connection device installed on the outside wall of the house. The NBN tech has had a look and said the other end of the conduit and the Cat5 cable (with one end already connected to the NBN box on the outside wall) are currently in the roof. We need an electrician to run the conduit and cable in the roof, drop them down in the garage, and make an Ethernet plate and a conduit hole on the garage wall next to an existing power point. Then the NBN tech can come back to install the NBN hub in the garage. We also already have a datapoint in the living room where we would like to have the modem. The NBN tech mentioned that the eletrician should be able to connect that to the point in the garage so we can still have the modem in the living room. Hope this makes sense, can provide more details if needed. Thanks.

We are installing a new kitchen and need 2 single power points upgraded to quadruples. We are also putting in a dishwasher and a new electric oven and need an isolation switch for the oven. The dishwasher won't be against the wall so we need a power source to run to it through the cabinets. We also had a fan installed in our lounge room but the last electrician put the fan switch on the wrong wall. We need the fan switch to be connected to a switch on the other side of the room and the light switch to be where the fan switch currently is (I hope that makes sense). If possible we would like an itemized quote as we may decide not to go ahead with certain things. Thanks!

Need to install a din meter to existing electricity box to check USAGE in rumpus room. Add 2 LIGHTS in rumpus room. In Campbelltown S.A.5074.