Find a professional garage door installer in Melbourne

My garage door works with two big springs. One of them just snapped today. One of the metal bits keeping it long has broken. My car is blocked in, so I need this fixed ASAP. I've put in the picture the broken (right) and non broken (left)>

This shed door gets roasting during summer and heats up the whole garage. Want insulation put on the inside of the door.

Key has broken in half in garage door lock. This task is to remove the broken key.

Belt broken dangling. Motor working fine. Looking for solutions. NO to onsite extra proposals.

have a garage roller door on site need it installed single door side rails and change the key barrel which i have

-Remove old motor -Install new motor -Single roller garage door Please quote for motor supply+installation as well as installation only

We need a person to do the garage doors maintenance. It is closing normally but making sounds and shaking a bit, when moving up and down.

Hi, I need a roller shutter garage door adjusted so that it can be raised around 100mm. The door is currently sitting too low and needs to be lifted to allow proper clearance. Pictures will be provided for reference. Please bring any tools or materials required. Location: Coburg Timing: Flexible, but sooner the better.

The wind has broken off one of the hinges from the back laneway car door. It’s a tall thin metal fence and door (similar to a shed). See pictures. At the moment it’s being held up by rope. Need someone to fix this on the 27th when we are home.

When the weather is cold my garage door often opens to 10% and gets stuck. It needs a few tried to fully get past the sticking point. Door isnt level and there is fraying on both side cables. Cables need replacement

Garage door not functioning properly after a little damage. Automatic system is no longer working and had to close it manually.

Supply and install a torsion spring on single garage roller door that rolls up. The spring needs replacing and part will need to be supplied please. Thank you for reviewing. Photos below.

Get a quote to repair garage door

DIY installation of motorised Chamberlain garage door opener for single roller

My garage door needs the cable realigned. It can open and close but beeps and stops multiple times. I’m renting so I just want to get it working so I can get in and out. I’ll be submitting it to my agent for maintenance anyway but as I store my work items in the garage - I just want it to open and close a bit easier at the moment as they take ages to organise repairs.

I want to drill a 10mm hole in each of the steel runners of my garage door (2 holes in total, 1 in each door) so I can attach padlocks to the runners to stop the door being opened.

When it's cold, our electric garage door doesn't go up and down easily. We have to get out of the car with the remote control and help to push it up or down, otherwise it only goes up or down a couple of inches at a time. It's not such an issue in summer. We're looking for someone to see if they can help to make it open and close more easily and reliably.

roller door cannot be locked as indicated in photo. Side could be not aligned where the lock could not be turned

Install Tesla home link receiver (part on hand) wired into garage door motor receiver so I can utilise homelink which has been installed in my car

Section of inside of garage door fixing bracket with roller is coming off the garage door. Roller is falling out of track. One side only. Seems like some bolts need to be tightened, and some replaced. Door needs to be pushed back into track etc. general maintenance. I will meet you at the house and will be able to assist with any additional lifting required