Find local power point installers in Inner South Melbourne

Install outdoor rated dual power point, must be rated to support 1800W. Existing power point is available, installation height around 2.5-3m.

Install a outdoor double power point GPO 15 amps. Cable run 10m. Double brick wall, able to run cable in between to roof.

I am building a new kitchen and need a power point for microwave cupboard, 2 new power points on my wall (it is concrete so would run on top of the skirting board) and connect an induction cooktop, attached is the kitchen and wall

Need to install one power point on tile wall in a bathroom, there are already power points on the other side of the wall. Need to cut on tile wall, must not crack the tile.

Need to install a power point on tile wall in a bathroom. There’s already power points on the other side of the wall.

One PowerPoint is buzzing and needs replacing, we have a replacement. A second outdoor PowerPoint needs replacing as when one side is off it appears to still be able to be used.

I would like to get 2 power points ( 1 in study and 1 in walk in robe) and get 3 ceiling fans installed.

I need to install this device with a power point move so need a verified electrician. https://nuracom.com.au/pages/nuracom-autonomous-drying-rack-installation-video-tutorial?_kx=kPpuI1Kvf5CD14e0HhZFeLGz9DqCO0OBdrgXGp6blNY.Usbaq6

We need a PowerPoint/light switch moved from one side of the wall to the other. The current switch is 7.5cm wide and the other side of the wall has a 9.5cm gap

Need to install an outdoor power point, and connect a plug to it. The plug is from a 15A SPA. Wiring to main switchboard already done for the 15A. Wiring already at location of PowerPoint.

Need 4 Power points run in a new workshop. Mezzanine level is exposed, so minimal drilling etc. 3 x 4 outlet GPO and 1 x 2 outlet. About 10 metres of conduit. 2 separate circuits with RGB etc. Plenty space in the fuse box. Happy with an apprentice etc.

- Two power points moved approx 400mm to the right on the same wall - Antenna socket to be disconnected A wardrobe is being fitted to this area so no plastering of the old holes will be required.

Need a licensed electrician to inspect and replace a cracked kitchen power point. It previously buzzed once and had a burning smell, but is currently no buzzing, smell or heat. Please inspect the wiring for any damage/overheating and replace the power point.

Looking for a licensed electrician to: • Replace 3 existing old/damaged power point/switch fittings shown in photos with new white fittings. • Supply and install 1 new four-outlet (quad) power point above the kitchen benchtop in the location shown in the photos. • The new outlet will be used for a microwave and air fryer, so please confirm the existing circuit is suitable for the load. • Please include supply of standard white fittings, labour and Certificate of Electrical Safety in your offer. Photos show all existing fittings and proposed location.

Install power point under a desk in the living room Fully licensed electrician For single dwelling

Licensed Electrician – 2 Small Power Point Jobs Looking for a licensed electrician to complete two relatively small electrical jobs at our home. Job 1 – create new PowerPoint..adjacent to existing port. Job 2 – Connect new double power point We have had a new double power point/faceplate installed in the kitchen. The hardware is new, however it has not been connected to the electrical wiring behind it. We need the existing wiring inspected, the new power point correctly connected and everything tested to ensure it is safe and operational. Photos attached showing both jobs. Please include labour and any standard electrical materials required in your quote. Licensed electricians only please.

We have just installed outdoor blinds that require a plug in motor. We need an electrician to supply a double power point to the ceiling of the alfresco area.

Hi I’m looking for qualified tradesmen to supply and install PowerPoint and antenna pint for tv

Looking for a licensed electrician to supply and install a 4-point power outlet (4 GPO) in place of an existing single power point. Important: The existing power point is installed within a skirting board that is 100mm (10cm) high, so the replacement power point must be 100mm high or less to ensure it fits neatly within the skirting board and does not protrude above it. Scope of works: * Supply a white 4-GPO power point. * Remove existing single power point. * Install new 4-GPO power point. * Test all outlets and ensure everything is working correctly. * Dispose of old fitting if required. Notes: * No wall repairs, patching, plastering or painting will be required. * Photos of the existing outlet and the style of outlet I’m looking for are attached. * Looking for a neat, straightforward installation with minimal fuss. I’ve listed this job at $120, so please keep quotes realistic and close to budget where possible. If there are any genuine reasons the cost would be significantly higher, please explain what additional work would be required. Location: Kooyong Timing: flexible

Put in 4 double power points