Find a professional staining service in Outer East Melbourne

Lining board removal, replacement and stain to match This lining board was cut out for a chimney (now removed). I need a carpenter to remove the old board, install a new one and stain to match the rest of the ceiling. Your quote needs to include materials, labour, install and clean up

I need my deck cleaned up, sanded and stained Most of the deck is under cover and in great condition, only the end is exposed Furniture etc will be moved for the process

Install stainless steel wire & fittings between timber post at the back patio for creeping plants

I need someone to sand and Stain by merbau deck ready for sale. It's is quite aged and will need a hard sand in the areas exposed to sun/rain. The area undercover will not be anywhere near as bad. Would like both areas to match as he's as possible Approximately 45 sqm I can purchase the stain

existing decking needs its annual staining. I’m not there to take particularly helpful photos but I have pulled some off my phone That may be useful The outdoor wood stain is a Cabots product Beach House Grey I have had a few new boards added that havent been stained yet at all

Stainless steel sheet metal work – food trailer Description: I have a stainless steel food trailer and need sheet metal fabrication work: 1. Replace the clear plastic panel behind LED lights with stainless steel sheet (food-grade, reflective). 2. Fabricate and install a stainless steel cover plate to close an electrical wiring opening in the wall (must be sealed). 3. Repair dents in stainless steel wall and checker plate floor. Work must be suitable for food trailer / commercial kitchen standards.

Hi, budget negotiable - I wasn’t sure on current cost of steel & install. We’re looking at some stainless steel railings that can guard our windows. The goal is to still let light in and not look too intruding to the space. 2 stainless steel rails could achieve this appropriately spaced in height. Fixings can be onto the concrete pillars or into the concrete slab. x2 15.08m width & 7.54 width for each section. Open to suggestions!

Deck sand and restain 9x3 meter merbau including posts, steps, and hand rails

1. Approx 85m2 merbau decking to be pressure cleaned, sanded and stained 2. Approx 17m2 Victorian Ash batoned feature wall to be washed, sanded and stained Must be professional, quality job. Pre inspection with prior to final quote preferred. Easy site access.

Looking to get our deck sanded and re-stained. Or just sanded. Back to a surface the we can then stain over. Deck is 10m x 12m plus some stairs at the front.

Sand existing coat and apply fresh stain to front & back decks as well as seating and stairs in firepit area

Looking for someone to sand and stain our deck, it’s quite small.

Approximately 35m2 merbau deck needs to be cleaned and 2 x coats of decking oil which will be provided.

looking for tasker to kindly sand and stain merbau deck. To ensure scratches are sanded and ensure no nails sticking out and then deck either in normal stain or oil based for longer duration and ensuring non slip. Ensuring during staining no stain on windows or brick work. Approximately 6 x 6 metres. Includes a step.

Deck was washed, sanded and stained 2 years ago. Ultradeck Timber Oil (some remaining, I think will need more) Preparing to sell house. Not sure if it needs some sanding or just pressure wash and re-stained (1 or 2 coats?). Please detail offers based on photos. 5.6 x 3.1m deck and 1.7x0.65 table to be stained.

Front porch sand and stain. Back gate level so it locks. Pool pump gate back on its hinges. Small corner painting. Ongoing household maintenance for the right person.

- Replace bottom posts on staircase upper deck area. Post top cut down to rail height, fit new capping rail - Pressure wash deck. Apply 2 coats of Feast Watson Wet Look deck stain

Small decking needing sand down and stain I can provide the stain

There are some brick got stained with waterproofing membrane, need to clean the brick as much as possible to not showing the blue

A deck which is ~50m2 need to be sanded and re-stained (2 coats). Nails will need to be punched. No idea of price so make me an offer. Ideally someone who’s has experience.