Find a professional staining service in North West Melbourne

Fix Issue Causing Wall Stains My offer amount is just to get the ball rolling, can discuss pricing after. Potentially overflowing gutter that needs fall adjustment and drip edge. Need expert opinion. I'm looking for a roofing/guttering specialist to inspect and fix an issue with one section of my upper-level gutter. A rendered wall on the upper storey recently had long vertical streak marks. The wall has been repainted, but I want to prevent the staining from returning. What I need help with: Inspect the problem gutter section (side of the house with the satellite dish, directly below the solar panels) Identify what might be causing the original streak marks on the wall Adjust the gutter fall if needed Add a new gutter bracket if there is sagging Clean the gutter (especially under the solar panels) Install a drip edge or gutter-lip extension to stop water tracking down the render Provide before/after photos Important background info: Only ONE area of the wall had streak marks — other areas were clean The marked area sits below a long gutter run that receives heavy runoff from solar panels This suggests possible gutter overflow, sagging, poor fall, or water clinging to the underside of the gutter I want a professional to confirm the cause and fix it properly Access: Two-storey house, tiled roof. Ladder required. Goal: Stop water from running down the rendered wall so the new paint stays clean for years.

Description: I need a welder to permanently attach 2 threaded bulkheads to a large stainless steel pot. The silicon O-rings aren't providing an adequate seal, so I want them welded in place. Details: Material: Stainless steel pot Job: Weld 2 bulkheads (there's already 1 existing bulkhead on the lid - see first photo) Locations: First bulkhead: On the lid (flat surface) - will be the 2nd bulkhead on the lid Second bulkhead: On the side of the pot (curved surface) The pot will have 3 bulkheads total when finished - only 2 need welding. Looking for someone experienced with stainless steel welding who can ensure a clean, watertight seal.

12 m by 1m front fence. Have stain and drop sheets.

I have a 2400 x 1200 sheet of plywood. I need an area of 2030 x 820 of it sanded and stained and sealed on both sides.it is going to be the back of a bookshelf so it needs to look nice. Sand up to 400 grit, and 6 coats of wipe-on Poly. I will provide the wood, the stain and the wipe on Poly. Sand paper too if you need it. You can take the plywood wood away to work on it in your own space, or use my carport, whichever works better for you.

The top of a wooden dinning table stain black

Need my front door stained. Want it to match the floors

Need front door stained by a professional

Remove power raid stains from carpet an bed mattresses carpet cleaning

Solid timber staircase needing sand and stain to refresh

need the smoke stain small patch on the ceiling

I need a scratch sanded out of 2 floorboards and stained

need help to clean the smoke stains on the ceiling. Its a very small patch

Deck cleaned and stained as well as the surround beams and garden bed planks

Deck sanded and stained including steps. Deck dimensions roughly 7.7m x 7.2m.

We have a large deck that has some old cabots aquadeck on it. It needs to be stripped (open to sanding but our deck builder said stripping would be safer) and restained. We also have two small area of new deck that need washing and staining. See photos. The dimensions are new bare deck (laid two months ago) - 15sqm treated weathered deck - 87 sqm

I need the front and back deck re-staining

Stainless Steel Bird spikes to be installed along the flat top ledge of the brick entry structure above the house number at the front of the house. This is the horizontal surface at the very top of the entrance façade where birds are currently perching, length 5meters.

Need a custom stainless steel bbq hot plate made 440 x 435….to look similar to attached

Sand deck and retain. No replacement of boards required

Deck and Staircase Maintenance: • Sand and re-stain the rear deck of the house. • Sand and re-stain the side staircase. Finishing: • Apply two coats of Cabot’s decking oil to all treated surfaces.