Find a local Tasker to inspect your Holden in QLD

Passenger side wiper is no longer working. The drivers side still works.

The Problem VF Evoke SW 2016. Cold start = fine. After ~20min or >28°C, loses pwr esp up hills. Severe cough/splutter WOT (foot flat). Struggles to hold 50km/h on Gateway Bridge, drops to 30km/h on steeper inclines. Air filter OK. Likely Causes (According to Repco staff guess): intake manifold / plugs / coil leads / torque conv. If I run the problem through AI (ChatGPT) its Diagnosis – step by step OBD-II Scan – chk codes (misfire, trims, cat eff). Fuel System – hot fuel pressure test after 20–30min. If drop → repl pump module & strainer. Air & Sensors – inspect/clean MAF, chk vac leaks, purge valve. Ignition – repl plugs if worn, test coils (swap/live misfire). Exhaust – back-pressure test or pull O₂ sensor to confirm blocked cats. Repl cats if restr. Oil & Filter – full change w/ new filter. What I Need Exp. w/ Holden Commodore/Evoke or 3.0L V6. Tools: OBD-II, fuel press gauge, back-pressure tester. Supply/advise on parts (pump, plugs, coils, cats etc). Step-by-step diag + summary after each stage. Budget 💲: Fair labour + parts. Quote for diag first, then fix options. Flexible if parts cost ↑. I can pick up from Repco/SCA to save time/$. Timing 📅: Flexible, but urgent as car unsafe on hills. 👉 If this sounds like you, pls make offer!

Need aircon replaced in 2016 Holden Colorado 2016. New blower motor and Fan Speed Resistor required. Can drive to mechanics or mobile is fine.

My gear stick head needs replacing, it's supposed to just screw off and be a 2-minute job, I just don't have the strength to remove it! If anyone has done this before and can help, I'd be really appreciative!

Our Holden Colorado is not keeping its charge, despite being on charger overnight. Need help sorting this out please.

Remove gearbox replace Clutch, flywheel and slave cylinder Put box back Ute In garage I have all parts

Cars already been registered in my name it just went past the 3 month cut off date.. cars fairly smick. New brakes new tyres new windscreen new rear tail lights

Front struts need replacing (new ones will be provided)

Hi i need a new rocker cover gasket for holden cruze 1.6 T 2014 - need to have mechanic evidence for road worthy

Broken side mirror (driver side) needs replacing. I have the spare part.

Headlight and indicator not working of RG Holden Colorado. Need a BCM scan to check diagnosis

Need my aircon regased in my car just looking for a quote

Supply and replace thermostat housing for Holden Barina 2015 1.6

2010 holden Commodore VE LF1 3.0. Maintenance, repairs

I have a 2013 Holden Colorado dual cab ute, and I need to have installed a reversing camera. I already have the camera, which needs to be wired and connected to an existing Android-based head unit.

I would like to arrange a full inspection and repair service for my Holden Captiva 2014. The vehicle has developed the following issues: Some unusual noises while driving Signs of a leak (possibly fluid/oil) Occasional hiccups/jerks in performance I’d appreciate it if you could check the vehicle thoroughly, identify any underlying issues, and provide me with a repair plan and cost estimate. Please let me know your earliest availability to book the service.

I have a 2006 Holden Barina TK 1.6 Manual car that needs some mechanical work to make RWC. *Airbag warning light is on - requires diagnostic scan to identify fault code and reset. *Parts At Location - Front and rear wiper blades (Rail Type) need replacing *Part At Location - Install and test the Speedometer that is not functioning - possible fault with the instrument cluster *Part At Location - Valve Rocker Cover & Gasket installation *Part At location -Change Spark Plugs *Provide RWC I need an estimate of labor costs to install parts that are already provided (onsite) into the vehicle, which is located in a garage (flat area)in Meridan Plains

Just needing a front left suspension strut (provided) fitted to my 2015 holden trax, can travel to you if needed, I’m based in Albany Creek. it’s the complete strut with spring

Needing someone to install a starter motor into a 2003 Holden combo I’ve removed the old starter an bought a new one just needing you to install the new one. Thanks

My engine oil cooling housing needs changing in my 2020 Holden Trax. The part has been bought from aus auto store, just need it to be replaced. I have my recent service that states it’s where the leak is from. Happy to have it changed at mine or if I need to take it to a shed/mechanic etc.