Find a local Tasker to inspect your BMW in VIC

Brake pads will be provided along with sensors. Just need the front and rear brake pads replaced

I have an open throttle DRL LED head light conversion kot i need installed. Its plug and play so just need to reach the back of the DRL headlight housing to swap plugs. Located dandenong

I recently purchased a bmw e46 2002 and my airbag light is on and it won’t shut off and I’m looking to get an airbag resistor installed to bypass it. I was wondering if maybe someone had a spare seat bypass resistor that I could purchase, I can install it myself but if I could just buy the part

Install portable wireless CarPlay screen (APHQUA A95) into BMW X3 E8 , hide wiring, connect audio via radio/cd input. I have already bought the unit and want as good an install as possible. Also run rear camera to the unit. I would like it to be powered by the cars ignition too.

Need someone experienced with BMW’s to replace a number of non mechanical parts: -replace inside roof liner (whole piece) -replace sunroof inside panels or replace whole sunroof -replace passenger side rear door and swap inside door liner -re-align drivers side rear door -stop start button swap -screen swap -replace buttons on idrive module -swap open/close mechanism of drink holders in centre console -swap plastic piece around cup holders -swap rear of centre console air vents. All replacement parts are ready to go. Is an E70 X5. Hoping to get it done this week or next.

I changed the cylinder head on my BMW 325i N52. Can you do diagnostics, adaptation reset, and any relearns/coding needed after head replacement?

Mechanical minded person familiar with BMW vehicles

Need to replace front breakpads in my 320d 2014 BMW.

I’ve purchased a new fuel filter and need someone to install it in my 2013 BMW 520D. Happy to drive down to you or your shop

Need Automotive Electrician / BMW Specialist - Ambient/Starlight Roof Wiring (BMW G20 LCI) I have a BMW G20 with an aftermarket starlight/fibre optic headliner already installed. Currently the lights stay on VIA THE cigarette lighter plug. I’d like them rewired/integrated properly so they: - Turn on when the car is unlocked or doors are opened - Fade off with the factory interior lighting - Behave more like OEM ambient lighting - Turn on at anytime whilst the engine is on Looking for someone experienced with: - BMW electrical systems - Automotive ambient lighting - CANBUS/interior lighting integration - Clean trim removal/reinstallation The headliner and lighting are already installed, so this is mainly wiring/integration work rather than a full install. Would prefer someone who has worked on BMWs or Euro cars before. Located in Lalor, VIC, 3075. Please send through examples/photos of similar work if possible.

Looking for a reasonable panel beater to see how much they can fix this Check the photos Let me know your cost

BMW 320I WAGON Need a diagnostic. The warning symbol has just appeared. Would like to know what engine light is saying the problem is.

Fit Dpf to bmw X1 Will need own tools Vehicle does not drive due to Dpf being removed . Is parked on a private drive on street next to my house.

BMW X5 2016 (F15) — Brake Inspection & Quote Looking for a qualified mechanic to inspect my brakes and provide a quote for replacement. **Situation:** Brake wear sensor light came on 4 weeks ago. Have driven approximately 200km since then. Car is driving normally but needs attention. **Service history:** Purchased the vehicle at 80,000km approximately 2 years ago. Now at 130,000km. No brake or rotor replacement carried out in our ownership. Prior replacement history unknown — may be in the logbook which I can provide for inspection. **What I need:** - Full brake inspection front and rear (pads, rotors, calipers) - Measure rotor thickness against BMW minimum spec — given the mileage I'm expecting rotors likely need replacing too - Separate quote for pads only vs pads + rotors so I can make an informed call - Advise on rear electronic parking brake caliper condition - Note any worn brake wear sensors that need replacing **Location:** Braybrook/Kingsville, Melbourne West Please only apply if you have experience with BMW or European vehicles. Must be a licensed mechanic. Happy to share logbook and discuss before booking.

I need help with installing exhaust headers on BMW S1000RR 2025. The person needs to be well experienced with this and needs to remove cats on the bike.

I have a 2008 530i BMW and I’m interested in having the unit installed

Towbar installation as discussed before

I need someone who knows e46 m3 gearboxes and can drop my SMG gearbox and reinstall a second hand option.

BMW 1 Series – 2014 model Require a basic maintenance service (oil, filters, general check). Not looking to spend a great deal as the car is planned to be sold mid-year — this is mainly for upkeep rather than a full overhaul. Also need the boot lock issue investigated and repaired, including any wiring faults related to the boot lock warning/error. Looking for a practical, cost-effective solution rather than premium extras.

Bent fender front on front right of my E39. Just needs to be bent back into shape