Find skilled builders in North West Perth

Looking for an experienced landscaper or concreter to fill in and concrete over an existing plunge pool in Edgewater. Pool volume approximately 5 cubic metres. Drainage holes have already been drilled through the base and are functioning well. Half of the brick coping needs to be removed (white markings in pics) Potentially some paving needed on border..

I need that part roof and wall demolished.

Supply + Install 6m Wide Swing Driveway automatic Gate

Looking for someone to assemble a Stratco Handi-Mate Sliding door shed (1.86m wide, 0.85m deep and 1.90m high). It also comes with a shed floor beam kit that needs to be fitted. It will sit on pavers and no need for anchoring. This will be behind the house in a corner. Area will be cleared prior to the assembly.

I need an easyshed 3m * 1.5m * 2.1m Skillion Roof Garden shed assembled and mounted on a new concrete slab.

Assemble and erect 4 X5 m prefabricated shed on existing concrete slab. All materials are included

I have an Easy Shed to be assembled on a concrete slab in Landsdale 6065. The shed is 5x3.6m, have all the hardware but no instructions. There are some drawings from the design phase of the shed. The shed will go in the corner of the property. Thanks

Render an electric and gas metering box mounted in brick work at the ront of the driveway .

Complete installation of the shed on the concrete slab

Experienced exterior painter to repaint the fascia/perimeter trim on a modern patio /pergola measuring approx 3.5 x 3.5 Existing paint has weathered and lifted in some sections, so proper prep is required. Job includes sanding loose paint, and priming, and repainting the fascia. Paint and materials to be supplied by you using a quality exterior paint, such as Dulux Weathershield, Haymes Solashield or equivalent - colour match existing paint. Important: Ceiling panels and timber posts are NOT included Care required around nearby pool area, to prevent paint flakes or paint to enter pool or paint on pool glass. Proper masking/protection and clean-up expected Good access with standard ladders only — no scaffolding required.

Assemble shed from Bunnings in Mindarie. The area is fully paved.

Brand new easy shed installation required. Pad is already down. 3m x 3m Needs to be bolted down to cement and sealed. Bolts provided.

The driveway is not a full-width replacement. It is mainly: 1. Removal of the existing concrete crossover strip along the road edge, 2. Tying into the existing expansion joint/new finished level, 3.Reinstating a narrower concrete section. 19m length, 1.5m wide and 200mm depth

Assembly easy shed 1.5*3 meter gatden shed

Adjusting pergola size and moving footing

Installation of insulated roof panels X6

Move outside aircon unit 2.5 meters out of new pergola area.

Help to Dissemble a 3×3m - mimosa louvred pergola. I bought online, mert at sellers house in Nollarama today. Please bring: Drill, ratchet set, Hand tools, Ladder, I dont know if bolts in concrete need sawn off, if you have grinder also would be useful. Work involves, undoing lots of Nuts/bolts each louvre, screws/Allen keys to undo fram connections. Its Aluminum frame, so careful not to thread. (Its happened before ). I can assist with my tools also and have a 1 x collapsable platform ladder. I would like your help to load into/onto my Van roof racks also. I'm 1 hr drive from location. So rbc a time with yourself and the place picking up from. Need completed Today. Thanks you

There is a bunch of rubble, gyprock, old wardrobe panels and general demolition waste that needs to be gathered up and placed in the skip bin on site. I estimate about two hours work for one person. There is a wheelbarrow on site to make this easier.

Need a shed assembled on a concrete slab. Shed is : 3.75m x 0.78m Narrow Slider Shed Arriving 6th Jan. So need assembly after that.