Find a professional bricklayer in East Melbourne

Need experienced builder/carpenter/bricklayer to create approximately 900x1200 access opening through external brick veneer wall for subfloor access. Scope includes: * Site inspection * Confirm suitable location * Cut brick veneer opening * Install lintel * Frame opening * Install access door/hatch * Weatherproof and make good Must have experience creating openings in brick veneer walls and be able to provide examples/photos of similar work.

Hello! The rear of my home was demolished, and with it a few besser block bricks (390x190x140). Five bricks in all need replacing. Ideally would like completed by Thursday midday if possible. providing bricks and mix please.

I have three large stones on my front garden that need re-mortaring. The stones have come loose. I can supply the mortar.

hey mate, my double brick house external wall need repointing.

Relay bricks on a patio step

The bricks on the exterior wall beneath the window need repair

Brick cutter needed to cut vertical single skin brick wall. Approx 2 metre tall easy access. No clean up required $ 200 job ready in Surrey hills.

Need renovation layout + interior direction for a 4-bedroom house in Balwyn. Including 2 ensuites layout, lighting suggestion and material palette. Not full service, design only.

Brick wall damage by car And this needs to be fixed properly as soon as possible before the rain comes on Sunday. Not enough spare bricks to cover all the broken ones. Please send me quotes roughly. Thanks

4 No. vertical brick cuts through 10mm brickwork. 2x2100mm. 2x2400mm

Need to cut brick/tile to create a path for water to drain. Allow drilling up to 8 weep holes. Use level to work our levels properly . The tiles has been laid so that the fall goes towards the corner of brick, water is pooling there.

I’m looking for a bricklayer for a small front stair project in Surrey Hills. Scope: New build (not repair) 3 brick steps (total rise ~500mm, ~167mm each) Stair width ~1800mm (with slightly wider bottom step if possible) Full concrete footing required (100–150mm with mesh) Top step will be timber (done by deck builder), so brickwork to finish just below Details: Tread depth ~285mm (bottom ~300mm) Standard brick finish (open to matching existing house brick or suitable alternative) Located at front porch (easy access) I can share a drawing/spec if helpful. Could you please provide: Rough quote Availability Whether you handle footing as well

Job Title: Brick Patching Job Description: A hole was created in a brick wall by an air conditioning installer during a previous installation. The unit has since been relocated, and the opening now needs to be repaired. The job involves: - Patching and restoring the external brick wall to match the existing structure as closely as possible Additional Notes: - Please bring all necessary materials and tools - Experience with brickwork is required - Clean workmanship and proper finishing are important Please provide a quote and estimated timeframe for completion.

Four bricks need to be relayed into a wall from which they have been removed

To remove old air vent and brick 2 pieces of brick to cover the hole

Repair an external brick wall which has been knocked off and repair to original position. About 75cm high.

Mortar is eroding at base of wall and bricks are cracking due to fence being installed. Job is to repoint and fix the wall - adhere the cracked bricks if possible.

Add 3m x 36cm of brick wall to existing wall. Bricks supplied

I Need this bricked up pls I have the brick You need to supply some white Bricky sand to match mortar Thanks

1 x wall requires brick stitching to repair cracks, approx 1.7m high. Crack stitch wires supplied by me to be embedded in 4 courses and all beds and peeps to be filled neatly. Install 1 x expansion joint in at brick expansion to be tided with mortar on right side splits.