Find a professional staining service in WA

Stainless steel coving needs to be done in commercial kitchen approx may be 40 meter. Thanks

Minor Restoration on timber decking. Sand, replacement nails & stain size 40sqm.

- cracked and chipped stained glass on front door

We are seeking a stainless steel fabricator with experience in piping, tubing, and bracketry within the food and beverage industry to assist with upcoming projects.

Carpet is stained from a pot plant. We have spare carpet to replace the soiled carpet. The stained carpet is the size of a dinner plate. The job is small.

Hi, I’m looking for someone to do a cosmetic cover-up of a small mould patch on a ceiling in my apartment. This is NOT a full mould removal job — strata will be handling that later. I just need it to look clean and presentable as strata keep delaying the date of repairs. Scope of work: Clean/wipe down affected area (mould treatment spray) Apply stain-blocking primer (to prevent marks coming through) Repaint ceiling area to blend in Details: Area is small (see photos) Standard ceiling height Ideally someone with painting/handyman experience Important: This is a quick, cosmetic job only Not expecting full remediation. Timing: This week if possible. In Highgate. Budget: Looking for reasonable quotes (this should be a quick job) Thank you so much !

These doors weren’t prepped properly and so the varnish stain looks very blotchy and scratchy. I’d like them sanded back and re done. They are jarrah doors so very heavy. There’s 2 standard doors, 2 pantry doors and 4 little cupboard doors. We will supply stain as we’d rather them stained than a varnish look.

Sand back / take off flaking stain, then restain to a good standard. Garage door. Only front needs doing.

I have a piece of hollow stainless steel tube (24 mm diameter and about 1 mm width) which I need cut in two pieces . Then another section of ( 24 mm diameter, 1.2 mm width 400 mm long ) stainless steel tube I need welded in between these two pieces. I have a Parrilla grill and want the axle/shaft lengthened. I have the steel piece but it needs to be cut back by 100mm as well. (Don’t know much about welding and whether anything else is needed, like an insert or something to wrap around it. Would need some advice on this.)

Repair cracked stained glass / leadlight window panel I have a decorative stained glass (leaded glass) window panel with a cracked clear glass section. The panel includes colored floral designs with lead joins. The damage appears to be multiple cracks in one section of the clear glass (currently temporarily taped). I’d like a professional to either: Repair the cracked section, or Replace the damaged glass while preserving the stained glass design Please include experience with stained glass or leadlight window repairs. Location: Brentwood 6153 Photos attached.

Outside deck needs sand and re-stain

Eh rear drip rail from wagon needs straightening without stretching

Hi i need someone to clean engine oil leak and stains on concrete.

Install a stainless steel rail (drilling into a stone floor) and also drill supports into wall. Then install a floating timber shelf above

U shaped deck. Need it cleaning and prepping for staining. 2 coats of stain to be put on. Materials will be provided. Need someone with experience of doing this.

5x5 deck area needs to be sanded back and oiled/ stained thanks

There is a stain from roof leak which strata are addressing and will also said they will fix my ceiling but they haven’t yet and I need it to look acceptable to rent

Small hardwood deck requires sanding. Roughly 20sqm. Sanding only.

I have the new door replaced and need someone to stain and Varnish to match the frame colour.

Approx 17.5m2 decking requires sanding and oiling after my tenants move out in April.