Find an affordable solar panel cleaning service in Outer South West Sydney

When booking solar cleaning services near you, expect a cleaner who has experience in cleaning both roofs and ground solar panels, the necessary tools for cleaning your source of green energy. They can also provide some solar panel maintenance advice. The goal is to clean your setup so that it can maximise the light in your area. 

The details of what your solar panel cleaner can or can’t do may vary, so it’s better to be specific in your task post. In general, though, the process of solar panel cleaning is pretty straightforward. This is what you can expect from your Tasker when you book a solar panel cleaning near you through Airtasker: 

Solar panel shutdown and equipment set-up

First, your solar panel cleaner shuts down the system before they start cleaning. Then, they’ll begin setting up their toolkit. If your panels are installed on the ground, this is easy enough; otherwise, your Tasker goes up on the roof to work there (or to move the panels to ground level). Make sure they have a hose or faucet near the area where you want them to start cleaning.

Note: It’s best to schedule a solar cleaning early in the day or late in the afternoon to avoid the heat of the day and smeared dirt (from when the water evaporates too quickly while you clean). 

Solar panel cleaning

Next, your cleaner removes debris, dust, or leaves. Then, they’ll hose down the panels. If your cleaning appointment is scheduled during the colder months, make sure they have access to lukewarm water. Using hot water on cold panels can result in cracks. 

Once the panels are soaked, your cleaner wipes them with a squeegee, soft brush, or cloth. They should not use detergents or abrasive materials on the modules, since this can damage them. If your panels have oil stains, they may use isopropyl alcohol as a spot cleaner.

Solar panels inspection

After scrubbing the panels, your hired expert gives them a final rinse and squeegees them dry. Since typical mains water is hard (mineral-rich), your Tasker must do this last step very well. Mineral deposits can harden on the panels as they dry. This can cause problems with your panels later on. Once your panels are clean and dry, your cleaner mounts them again, turns on the system, and checks to see if they work well. After that, your solar cleaning service experts will be on their way.