Find local power point installers in Sydney Eastern Suburbs

changing power points at least six

Remove power point and make safe for wardrobe installation.

We need 4 pendant lights installed (the original ones have already been removed) and light switches/ point points changed

1) We would like to install 12 power points. So we already have a few power points in the wall but would like to add 12 more. 2) We would also like to add 24 LED ceiling lights. Again, there are already some ceiling lights, but we would like to add 24 more. I’m assuming that both the above tasks can be done in a day i.e. 8 hours. I’m understanding if it takes more hours. Happy to pay $90 per hour for labour and additional for materials. Free and convenient parking is available in the building.

Handyman/Electrician to tighten the loose power point.

Only one power point with one outlet in living room so want to put in 2-3 more power points by running an extension line. Tasker came over and then failed to complete the job. Initially wanted to clip down the cord but then told me it wouldn’t look good so couldn’t do it, also said he didn’t have conduit to do the job and left second power point unconnected and wonky. Suggested someone run a conduit to connect new power points. I have purchased 3x power points + housing and if possible another antenna outlet on correct side of the room and power point on wall on other side of entrance. Please see photos. Can purchase conduit (probably 16m so about 30) eg. any necessary material needed

Need someone to swap old dated looking power point with a new one. All works fine, just want a new one swapped

Change down lights from transformers to 240 power points, minimal rewire, points, and lights provided. x 16 units.

Install PowerPoint to available electrical cable. As per picture. Run new cables under the house for 3 new PowerPoints. All material needed will be supplied.

I need a power point installed in a new house for a fridge in a storage room. The electrician from the build said it needs to be done via a conduit. The distance to the back wall is about 2.4m and ideally for a fridge to be about 1.8m high. Job is supply and install of the GPO via conduit.

Change 6/7 power point, already have everything you need

Change a looser point and a light socket

Fix existing power point Install new power point Experienced and licensed electrician required Must bring own tools and materials

Replace two fire alarms and install a 15 Amp power point (for a swimming pool heat pump)

Add two power points on skirting board on either side of existing power point

I need a qualified and licensed electrician to assist with the following items in my kitchen: 1. Disconnect old electric stove top and connect a new induction stove top, including any upgrades of the wiring / connections as needed to support the new induction top 2. Disconnect old oven and connect a new oven, including any upgrades of the wiring / connections as needed to support the new induction top 3. Add in a power / plug point connection on the wall (double powerpoint if possible). Appears to have been one there previously with existing cabling, however this may need to be redone (photos of the wall powerpoint cover and the wiring behind the wall which is in the cabinet on the other side of the wall) Items bought: - Induction top: https://www.ikea.com/au/en/p/matmaessig-induction-hob-ikea-300-black-10467267/ - Oven: https://www.thegoodguys.com.au/technika-60cm-10-function-oven-steam-bake-air-fry-to6010atb

I need 4 x 10w wall mounted lights fitted to a cavity wall , power is located in the wall also need a surface mounted gpo put outside and the power would by fed from the bulkhead above ceiling , I will supply all the fixtures and fittings needed as well as conduit for the surface mounted power outlet

It’s only one power point (left) out of the two that’s not working. The rocker switch for that one has been a bit dodgy/floppy (no click when switching from on/off) since we moved in, but it worked fine. Until now. Photo of the switch we need is attached, although we are happy to purchase this ourselves online unless you already have one. Note: there is a light switch in the middle that is in use so it needs this switch

I have a burnt power outlet I need change.. possibly a few other things happy to start with this.

Install 4 x power points in kitchen which need to be chased in brick wall