Find local power point installers in South East Perth

Need an certified electrician to supply and install a new power point as the current one sparks when turning on

Install 10amp and 15 amp outdoor power points. The cables are already pulled through the house and the conduit with pull wire to the outdoor location has been laid under paving. Will require new circuit breakers to be installed. Have added price in the budget section but happy to negotiate as I do not have any quotes

I need to put 2 power points in kitchen and theatre and also one light . It’s 4+2 single story home. Based in Wilson suburb

Change a 3phase outlet to a 15amp outlet. I have the parts on site

Require someone to install a power point outside of my house for a rainwater tank pump....

bathroom reno in 1970's house. i need double powerpoint installed. haf the house is on limstone blocks so i think the power points are running through the floor and the light switches are running through the roof. there is a small cavity that runs under the house that could possibly be accesible

Looking for sparky. Need to relocate a powerpoint x1 and change the lights around house around x 12 lights as picture of lights

Electrician also required to install tv plug and power point on single brick wall behind tv. New plugs requires approx 70 cm chase from the existing plug and power point directly below the existing tv. I will do plastering, repainting and clean up.

Need a 15 amp outdoor power point installed in pool area. Also, may need a couple of power points with tv antenna points indoor.

New 10A Power Points (4 Total): Supply and install four (4) new 10 Amp power points (GPOs)

I need to shift one power point in my laundry as I am installing new cabinets. Also I want to replace two outdoor ceiling lights with something similar with motion sensor Can

Hi, i have a tiered fountain that i need to work. There an old power point in the flower bed below that has stopped working. I need this moved to outside the planting area and the fountain reconnected with some feature lighting. Will buy material once advised what i need. Posting cost but really unsure what something like this costs to get done. Please help!!

The wires are all ready for the new lights. I have had some plaster work done. Where the power point needs to go is a hollow wall.

Need a power point installed under the bench for a new plug in oven. Have the wire there from the old oven just need a power point. Either Thur or Fri would work.

Install new powerpoint Tv hung

Place power point in pantry

New kitchen range hood installed has a 3-pin plug, however, current arrangement is 4-pin outlet (see photo below). The active 4th pin triggers a secondary extraction fan, that connects to the conventional 3-pin power point seen in the bottom part of the photo. I need to wire the new range hood to a 4-pin plug, as the one shared in link and image below or a current sensor.

New kitchen being installed, will need additional rcd for oven. Power point in island for dishwasher and additional power point. Plumbing already relocated.

I’m looking to install a new double power point in the bathroom for my dryer. It’s an exterior wall, and I assume it’s a double brick wall. Photo attached

Just replace switch. 5 switchs