Find professional pool gate repairs in NSW

Need a pool gate installed in a commercial warehouse around a door

Need to extend the pool gate to another 60cm for council compliance，I need to get rid of the acrylic glass and add the same fence on top of it, it is in the picture and would be about 5 meters， and should include material，please give me a quote.

I’m looking for someone to adjust the hinges and the closing mechanism on my glass. Pool Fence gate. It is not latching at short opening spaces.

Hi pool door needs slight fixing for compliance It won't close by it self when left open And the lock is abit worn off needs manually to lock it

Glass pool gate is not auto-closing. It appears to be a problem with the hinges, unclear whether they can be fixed or need replacing.

Got two pool gates that need a quick fix — they’re not auto-latching, which is a pool compliance requirement. Should just need a minor adjustment, nothing major. The gates themselves are fine, no replacing needed. Also need a 60-degree plastic safety cover fitted over a power point near the pool

Require someone with experience to install/repair Polaris pool gate hinge I purchased.

Install pool gate safety latch and hinges

I replaced the hinges and gate lock on a garden fence but the gate doesn't open properly. I think the issue is that I need more space between the latch and hook. The challenge I have is that I can move the gate further away becuase it is too close to the bolts that is holding the other fence on a brick wall

Pool gate latch needs tightened or replaced

Hello, Could you please advise cost to modify the gate pictured to a hinge compliant state? Picture attached. The tops of the hinges are 630mm, while the rails are 1000mm apart. We are in Seven Hills, 2147. Thank you.

Council inspection find out that pool gate not automatically locked when released from very close. Need thorough check and fix the gate

The lock/ catch on the pool gate has worn or loosened and now doesn’t close or automatically lock

I have a frameless glass pool fence and I need a gate installed. I have the glass panel there but needs to be cut to size. I don't have the latch or hinges, only the glass.

Need the magnetic attachment fixed as the gate isn’t closing properly

Pool gate glass panel was smashed and need replacing - need new panel (6mm glass thickness) supplied and installed (can use existing hinges and closing bolt fixtures - or new - either way is ok) No need for broken glass disposal - it was already cleaned. Panel measurements - please note those are taken by me - pictures as reference - 6mm thick - 1162mm tall - about 920mm wide Please refer to pictures - but it need to be on site measured before ordering panel ... Address of the job in in Mosman Please ask if need more details - thank you

I need some kind of pool gate for an opening 1500 and some kind of temporary fencing on a deck

Door is sagging and not closing

Need to weld pool gate latch back on. See photo

Currently the gate can not locked automatically as it is lower, I have to pull the gate up to click to the locker, so I need someone either reattach the locker or make the gate a bit higher to fix it.