Find local mobile mechanics in VIC

Son's damaged Mazda 3 BK needs the following parts removed: Bumper, RH headlight, washer bottle, RH front guard Replace with parts I have here from the wrecker. No painting needed, just remove old parts, fit and align replacement parts. Time estimate: 15 min remove parts, 1hr45min refit parts. Bring own tools. Available during the day.

Car turned on but will not crank over to start motor. Possible fuse or starter issue

Car won't start. Replaced manifold gasket. Fleeing domestic violence and can no longer get to my car

The back left corner bracket of the wind up wire mechanism has snapped and we need this replaced asap! Only the front two poles will lift.

Tyre is new and size is 110/70 R17 There is a screw in it I can take it out and bring it to your place If you can take it out of the rim, repair the hole from inside properly, and install back to the rim and balance i will come and take it back I prefer someone nearby Time is flexible Thanks

Mitsubishi Challenger 2010 model has engine light on and has been scanned. It says it is the fuel injectors. Hoping someone can come today and bring necessary materials to fix so it is driveable again budget is flexible depending on the job.

Rear passenger guard damaged when rubbed on fence, also both mirrors have top coat peeling. Want to repair for sale purposes

Hi, I’m a mechanic trying to start my own mobile mechanic business . at the moment I can only work weekends or after 5pm on week days. what I offer! servicing, diagnostics, mechanical repairs big or small, we also offer small puncture repairs to get you back on the road asap. If there’s anything I can help with feel free to reach out and I can come to you and give you a free quote

Service 2013 Audi Q3 TSFI Automatic Quattro MY13. Check brakes and general servicing. 145,000km.

Hi, I’m looking for an experienced mechanic to carry out the following work on my car: • Replace front control arms (pair) • Replace front brake pads Vehicle: Kia Cerato Koup 2010 🔧 I have the parts

Need experienced mechanic service 2 cars – must follow exact oil change method. Oil and filters Supplied Description: Looking for someone to do an oil and filter service on 2 cars. This is not just a normal quick oil change. I want the job done exactly to a specific method step by step, so I need someone who is careful, patient, mechanically minded, and happy to follow instructions properly. Please only apply if you’re confident doing the below exactly as requested: Required oil change procedure: 1. Start with the engine completely cold. 2. Add about 1 litre / 1 quart of fresh oil to the existing oil as a pre-flush. 3. Start engine and let it idle for exactly 5 minutes. 4. Turn engine off and wait 10 minutes. 5. Then drive the car 10–15 minutes to full operating temperature. 6. Park on level ground, let it idle 2 more minutes, then drain the oil immediately while hot. 7. After the first drain, leave it for 30 minutes, then remove the drain plug again and do a second drain. 8. Fit new oil filter, but pre-fill the filter to about 60–70% with fresh oil first. 9. Apply a thin film of oil to the rubber gasket and hand tighten only. 10. Refill engine slowly with about 80% of oil capacity first. 11. Wait 5 minutes, then top up slowly in small amounts, checking the dipstick each time. 12. Final oil level should be around halfway between low and full, not overfilled. 13. After refilling, do not start the engine straight away. 14. Turn ignition on without starting, wait 10 seconds, then turn it off. 15. Repeat that 3 times. 16. Then start engine and let it idle for exactly 3 minutes without touching the accelerator. 17. Check for oil leaks around drain plug and filter. 18. Turn engine off, wait 2 minutes, then re-check oil level and top up if needed. Must Have • has experience servicing cars, or is very mechanically capable • has their own tools • works cleanly and carefully • is happy to follow this exact process, not their usual rushed method

Truck leaking oil when moved not leaking when stationary. Prefer someone with a roadworthy licence

I changed the bars on my motorcycle and now bike will crank but not kick over. Maybe a spark plug issues or a fuse short. Bike is a 2007 Suzuki Boulevard C50

Need a spare tyre changed on my car quick job

Oil change/filter check brakes

Need a mechanic to replace crank position sensor on 2018 px2 ford ranger 3.2 diesel

Looking for a diesel mechanic to service my fuso truck and ideally tilt tray also

I need tensioner pulley and other pulley changed on a v6 lion motor in a territory v6 diesel,i have both new parts just need old ones removed and new ones installed

Require a Diesel Mechanic to perform Mercedes Viano DPF regeneration To be done onsite at our warehouse Bayswater 3153

Hi, I have a 2008 Toyota Corolla hatchback. The yellow engine light has come on (solid). The car was running fine earlier, but after putting it in reverse it started shaking while driving. Symptoms: Car shakes in reverse and drive Slight shaking at idle Solid yellow check engine light Was smooth before this happened Looking for someone with a diagnostic scanner to check the codes and inspect what might be causing the issue (possible misfire?). Car is located in Werribee. Please let me know. Today if possible Thanks.