Find a local Tasker to inspect your Mazda in Inner South Melbourne

2011 Mazda 3 Neo (BL) – Head Unit, Reverse Camera & Front/Rear Dashcam Install - Non-Bose / non-amplified car model. - Preferred install date: 23 Feb onwards (flexible if needed) Parts Supplied by me: • Pioneer DMH-AP6650BT — Head unit • Aerpro AKMZ4 — Fascia kit • Aerpro APP8PIO9 — Pioneer harness • Pioneer RCAMAVIC — Reverse camera • Viofo A229 Plus — Front & rear dashcam • Viofo HK4 (USB-C) — Hardwire kit SCOPE: Head Unit: • Install using supplied fascia & harness • Retain steering wheel controls • Route USB into centre console (secured, not loose) • Mount microphone near rear-view mirror or high on A-pillar Reverse Camera: • Mount centred above number plate • Wire reverse trigger correctly (auto-switch in reverse) Dashcams: • Front camera high centre behind rear-view mirror • Rear camera high centre on rear glass • Hardwire using supplied HK4 via fuse tap (ignition/ACC preferred) • Concealed wiring, no loose trim Clean, factory-style install with everything functioning correctly. Please confirm any: • Experience with Mazda 3 BL installs • Workmanship warranty (if offered) • Availability from 23 Feb onwards Budget set, open to discussion based on experience and quality

Hi, I need replacement of the alternator and the right-hand CV joint boot (drive shaft boot). Car: Mazda 6 (2008) I bought its alternator already but for boot, I am not sure if only boot could be replcaed or complete shaft drive? Could you please provide the price for each part and the labour cost for replacement?

Hi there, I’m looking for an experienced auto electrician / car audio specialist to diagnose and fix an issue with my 2017 Mazda MX-5 RF. Issue: • No sound coming from speakers • Radio, Bluetooth and infotainment all connect and display normally • No audio output at all (no radio, no Bluetooth, no alerts) • Vehicle has a factory Bose sound system Background: • Audio was working normally previously • Recently installed a GPS tracker connected to the battery terminal • Suspect it may be related (blown fuse, amp not powering up, grounding issue, etc.) What I’m after: • Diagnose the issue • Fix on the spot if possible (or clearly explain what’s needed) • Happy to pay extra for parts if required Vehicle details: • 2017 Mazda MX-5 RF • Factory Bose system • Automatic

Hi there, Need a professional to Repair Rim / Curb Rash Rim on three x3 rims of Mazda Mazda MX-5 2017. Based in Bentleigh East, VIC

Looking for an experienced panel beater (mobile or backyard setup welcome) to repair front-end damage on my Mazda 2. The bonnet is bent and misaligned and will need to be repaired or replaced, along with any other affected front panels. I’m open to your professional judgement on the best approach. Photos are attached. Scope of work: • Repair or replace the bonnet • Repair or replace any other affected front panels • Supply and fit parts if required (used parts are fine) • Align panels so the bonnet closes and sits properly This is a private job (not insurance). I’m not chasing a showroom finish — just a solid, safe, and presentable repair. Location Private home driveway Happy with mobile repair or to bring the car to your workshop/backyard setup.

Installation of new dashcam (front and rear) - model: 70mai A800 with hardwire kit on Mazda Cx80 PHEV.

New car alarm to be installed. Needs to get a quote and warranty

Current 2016 SP25 Mazda 3 has Bose sound system which continually blows its speakers and need replacing. Want to find an experienced car audio electrician to source and install a new system for all speakers and potentially a subwoofer. Will talk about specific details when an offer is received.

I am selling my 2015 Mazda 3 and would like to fix the blown front right speaker before listing it online. The speaker is not a Bose system, just a standard speaker from what I can tell.

Oil filter and change and reset the service light. I can supply parts/ oil.

Install DDPAI Z60 Pro front and rear cameras. • Preferred power: DDPAI Type-C intelligent hardwire kit (enable 24-hour parking mode with battery protection). • Power source: Fuse-tap to ACC and BATT (installer to verify with multimeter). • Typical CX-8 map: ACC via F.OUTLET in cabin; BATT via ROOM in engine bay — confirm on-site. • Neat, hidden cable routing: A-pillar (airbag-safe), headliner, through tailgate grommet to rear glass. • Clean mounting of both cameras, set correct lens angles, tidy excess loom. • Ground to suitable chassis point. • Configure app, verify live view, loop recording, parking mode and low-voltage cutoff. • Demonstrate event clip save and time/date sync. Deliverables (acceptance criteria) • Front and rear cams firmly mounted; trim refitted without rattles. • No airbag/SRS interference; no warning lights. • Hardwire works: camera switches between drive and parking correctly; no accessory-port obstruction. • Fuse taps labelled; wiring secured with fabric tape or loom (no buzz/rub). • Brief handover: which fuses used, cutoff voltage set, and basic troubleshooting. What I’ll provide • DDPAI Z60 Pro dual dash cam. • DDPAI Type-C hardwire kit (or OBD kit as fallback if you advise). • MicroSD card (high-endurance 256–512 GB) — or purchase from you at cost if preferred. What you provide • Professional installation and tools (trim tools, test light/multimeter). • Add-a-fuse taps and spare fuses — likely low-profile mini (ATM-LP) for cabin and mini for engine bay, but please bring an assortment and verify profile. • Cable sleeves, fabric tape, zip ties, alcohol wipes for glass prep. Please share experience and any photos of previous installs.

I have a Mazda 3 2016 BM and need an aftermarket new head unit with reverse camera installed

I need a tow bar fitted including wiring on a Mazda 3 2010 Sedan.

Need a service for car. Preferably done today.

Would like to know how much it costs to purchase and install head unit, dashcam, and reverse cam on mazda 2 2014.

Have a dash cam - need it installed.

Just looking to get the rear bumper replaced on my friend's 2014 Mazda 3 Skyactiv White. It's got a dent around the back left and it's on the reflector as well. Would be great if everything could be supplied and I can just drop the car off, however happy to source the bumper myself as well if need be. Just put $500 as completely clueless on price.

update mazda 3 with new apple car play unit. screen not required.

Hi, I need a licensed mobile mechanic to inspect my 2015 Mazda 3 for a persistent ticking noise coming from the engine, even when the engine is fully warmed up. The car was just purchased from a dealer. I need an independent opinion before I take it back to them on Wednesday. I’m specifically looking to find out what the cause of the noise is and whether it’s anything serious like valvetrain or timing chain issues. What I need: - A mechanic with a valid license or ABN - A written or digital report (PDF, email, or text is fine) with your business details - Ideally someone with experience diagnosing engine ticking noises - I can send you a video of the sound beforehand if needed Availability: Preferably today (Sunday) or tomorrow (Monday). Location is flexible — I can meet near Patterson Lakes or nearby suburbs if that helps. Please include your availability, whether you can provide a report, and your quote. Thanks.

Looking for someone who knows about cars, particularly mazda cx5 (2023 model) to install a subwoofer and dash cams. I have all the parts to install (took subwoofer off my old car and want to move into new one)