Find a professional internal door contractor in East Melbourne

I have 2 internal door handles to install that have a latch lock, we had one installed already but it was a little difficult because the person didn’t have the right equipment to drill out the expanded space required for the size. The first 2 photos are the ones we want to replace and the last 3 photos are the new ones. Some help with touch ups after installation is required, I can provide the paint, just bring a paint brush

Internal Door has been damaged. Needs repairing. If repair can't be completed, happy for the door to be replaced.

Installing 16 new internal doors (bedrooms, bathroom etc). 4 hinges per door. Flush (herline) hinges so no need to cut

I have had boards installed & carpet removed so doors are now too short. Also the latches where the handle clicks in have been painted over as have the hinges.

Need a carpenter to switch door opening from left to right. Need to move 3 hinges. Route 3 hinges on jamb and potentially door.

I require a qualified carpenter to swap over 4 old internal doors with new ones. Doors and door hardware have already been purchased. Doors are 2040 x 820 x 35. Please only qualified carpenters should provide offers.

Install indoor door for 270 cm height

I need a new internal door to be hang, the door may need trimming to fit properly. Additionally, I would like a new door handle to be fitted to new door. Handle and door supplied.

I have to replace two internal doors. One is 23250x820x35, the other one is 23400x815x35 I intend to buy internal doors from Bowens and your job would be to cut them to size, drill the handle/lock holes and cut out recesses for the hinges. I’ve got the old doors here so that you could measure them again.

Replace door knob fittings with door handle fittings, 5 internal doors . Remove existing door knob fittings. You will need to make a larger hole in the door to fit the handle mechanisms. I have purchased the new door handle kits. See pics

Internal Door puncture requiring fixing.

I have had two standard hollow core doors installed internally by Doors Plus and need someone to install their new door handles. They’re not “standard” door handles, they are from ABI. 2x “Davis” door handle (bedroom and bathroom) 1x “Dion” Privacy Snib lock (bathroom) I also need the handyman to shave off a few mms at the top of the bathroom door as the installer installed it too close to the door frame which means I cannot hang anything (like the mirror in the pic) and then close the door. Please state if you can do the job this week Sun-Tue (26-28 January).

Our study office need an internal door. We are purchasing 1020x2040 door (glass and timber) however the entrance is bigger than this, hence need plastering (not too much, few centimetre top and right border) to fit the door

My bathroom door is rubbing & scraping the floor.

I have 13 new internal doors which I’d like painted and hung. 3 are sliding doors. I will supply the doors, the hardware (hinges, handles) and the paint.

2x internal doors not closing properly. Assuming just due to normal building movement, etc.

Remove old door; supply, install solid core door. Reinstall door handle. No need to paint

Hinge on the toilet door has come off . Need it drilled back on

I have 10 existing internal doors that need to be adjusted/resized slightly as they don't shut properly after restumping and painting To be done BEFORE this Wed 22nd May if possible

There are two spots where at the bottom of my internal door frame, rotten timber needs to be patched or repaired.