Find a professional garage door installer in Inner South Melbourne

Two single timber garage doors need sanding Filling and restored with stained poly coating /2 coats Inclusive material Start to finish with clean up pls Experience need operators only with good references

We have an existing sectional door, however it is too low for my four-wheel-drive. If we could also consider a side motor for the garage door to give us extra height.

Looking for someone experienced in cedar timber restoration to bring our garage door back to life. The door was finished last year with Haymes Exterior Clear and a section has already faded from sun exposure. We’d like to fully restore it to its natural fresh, rich cedar tone and set it up for easy long-term maintenance.

We measured 4.7 metres wide.

We have a double tilt garage door installed that needs colourbond cladding applied to the front it as well as the same matching cladding around the door on the facade.

The garage door closes and then won't stay closed. It opens up about 500mm

90% of the paint is stripped and i need the garage door painted by tomorrow 8th April. I have the paint already. Needs 3 coat.

Have an existing car port. I have an extra car spot before that port. I would like to install a garage door flush with my house brick wall. I posted examples of what I think could look good. Open to ideas also!

Need paint removed from these aluminium doors

Garage door not closing all the way. Have tried close force and close adjustment but door bounces back up

Remove old garage doors and stack them in the garage as I am going to have windows and sliders put in their place.

Garage door spring replacement B&D double tilt door (5.3M wide, 2.45M high). One of 4 side springs has failed - assume replace all on both sides 560mm length of spring (body, 610 hook to hook) 40 mm diameter.

Need someone to program a remote According to you tube it’s a minute job for the right person Located in Hughesdale near Chadstone

Replace the battery of the wall unit of the garage door opener

I have 2 garage fobs, and 1 keypad entry. I require assistance to get these configured on the same garage frequency.

Quote to exclude cost of paint but must include spray gun and other materials. Garage door is 2.8m x 2.2m.

My garage door needs repair. I need to manual push the gate when opening and closing.

Cables have come loose on garage door, need rentensioning / balancing. Springs are only a year old.

Need to install a deadbolt to an extra garage door (deadbolt supplied).

I have lost my garage door remote. I’ve bought some new ones and need someone to code them with the garage door motor. Here is a link to the remotes. https://www.ebay.com.au/itm/111642040442?mkcid=16&mkevt=1&mkrid=705-154756-20017-0&ssspo=mfQPikL_RU2&sssrc=4429486&ssuid=F54U5Mh6R1C&var=&widget_ver=artemis&media=COPY