Find trusted local electricians in Underwood QLD

Looking for a licensed electrician to install 9 LED high bay lights at our furniture showroom in Underwood, QLD 4119. Scope of work: * Install 9 LED high bay lights. * Run and connect all necessary electrical wiring. * Divide the lights into multiple groups with separate wall switches. * Supply and install switches, wiring and necessary electrical accessories. * Ensure all installations are safe and compliant with Australian electrical standards. Site details: * Commercial furniture showroom, approximately 290 sqm. * Ceiling height: approximately 4.6 metres. * Lights will be supplied by us. Please provide a quote for labour and installation materials, including any required access equipment. Licensed electricians only.

Power point need to be fix in Underwood

Dimmer switch doesn't turn off. Fix or replace as needed. Old box pictured. White colour is installed. Supply and replace existing faulty Voltex DM300S trailing-edge push-button rotary dimmer. Existing unit dims normally but push-button no longer clicks or switches light off. Existing wiring/location unchanged. Licensed QLD electrician only.

Need a quote to install a light fitting "Jordan 70cm flush mount from Designer Chandeliers." The light fitting will be installed replacing an existing batten with sufficient nogging behind it. Will be installed at a ceiling height of 2.7m. Need an accurate quote

The scope is as per below: 1) Install 5x feature lights on external boundary wall (12VDC). Pre wiring already done 2) Install 4x step lights (12VDC). Pre wiring already done. For 1&2 existing Jb to be repalced with larger one to house driver and tie in to existing 240vac JB. 3) Install 3 x feature lights to house on existing JB. 4) Install outdoor power point in front of house. Pre wiring already done needs to be terminated at both ends. Power point to be supplied. 5) Install outdoor power point in backyard on garden bed retaining wall of house. Pre wiring not done. Conduit exists to run cable and terminate at both ends. Power point to be supplied.

Quite a few electrical works required but as a higher priority at minimum installation of 3 LED mirrors but for the right quote happy to provide a list of all items that need to be done.

install a second tesla car charger there is already one installed. run a conduit along the garage and install this one on the other side of the garage three phase connection distance between the two chargers is around 6 (garage door opening)

Looking for solar and battery accredited electrician for sub contracting work.

An electric car charger needs to be installed at my property in Underwood, as my BYD Sealion 7 is arriving on Tuesday, 31 March 2026 I done have anything Charger or cable.

Need a licensed electrician / solar electrician in Brisbane for a small rooftop solar wiring repair. I already had an inspection done and was told the issue looks like incorrect wiring. Need someone to: • inspect the relevant solar wiring • fix the incorrect connection • test the system properly afterwards • confirm it is working safely and normally If any connectors need replacing, please advise separately. Must have experience with solar systems, not just general electrical.

Looking for someone to disconnect hot water system then re connect at a later date after install

Need to install 3 led mirrors on bathroom vanity Wires are behind tile , need to drill and get out wire . powerpoint is already there

Looking for electrican can do connections for electrical gate for entry with conduit and light connections for front wall lights. i have all provisions installed already. got my all lights. need electrician to fix it

Looking for electrican can do connections for electrical gate for entry with conduit and light connections for front wall lights

Power supply for pool pump is dead. Test power and repair to restore power supply.

My bedroom 3.5kw split-system air conditioner turns on normally. The indoor fan blows strong air and the outdoor unit runs, but no cold air is coming out. I checked the pipes: The thick pipe is not getting cold, The thin pipe becomes cold, which suggests a refrigerant issue or possible compressor problem. I'm looking for someone to: Inspect and diagnose the system Provide a quote for repair (gas refill, leak check, parts replacement) OR provide a quote for full unit replacement if needed Please include any call-out fee or labour fee in your quote.

Want smoke alarm compliance certificate, All smoke alarm was already installed as per the new regulations (each rooms) and tested. Also test remote control is handy to perform the test. Ready to go,Just need the compliance certificate

I need to change an existing light fitting (old circular fluoro non-LED) in laundry room with new replacement LED fitting. See photos of existing fitting and new light to be installed.

Supply and fit (replace existing) super bright LED down lights x9. Sloping internal roof - 16ft at highest point. Will need a BIG ladder. Qualified electrician only.

I need an existing non-LED (old circular fluoro) light fitting in the bedroom ceiling removed, and replaced with an LED light fitting. See photos attached of existing fitting, and new light to be installed.