Find trusted local electricians in Richmond Tweed

Pick up 125 litre hot water heater and you can drop it off for free at Reece plumbing Tweed Heads.

We have an 8.2kw split system to be installed, back to back installation, single level, colourbond roof, about 15m to switchboard.

When I turn on the lamp switch, it has been sparking, humming and the light flickering. However, now there is no light.

No spark issues replaced stator and spark plug

Check over electrical circuitry. And fix any issues. In a caravan that is serving as a home on my property. Has both 12V and 240V lights. Check power points. A general maintenance call out. To a location about 30mins outside Kyogle Country. In the Border Ranges region of NSW.

Check and when necessary fix 12 volt circuitry in a caravan. Two pumps air conditioning and lights should be pretty simple

I need a licensed electrician to install a new power point directly behind my wall-mounted TV for a clean, cable-free finish. TV is already mounted centrally on the wall. Current power source is approx. 1.5m away from the TV (see attached photo). In the corner of the room or the air con above. Task includes supplying and installing a new double power point. Must be completed to Australian electrical safety standards. Kingscliff Please provide: Quote including materials and labour, confirmation of availability and qualifications. Thank you

I have a short in my truck

What's in the original task

Looking for a local, licensed electrician to complete some installation work. All fittings and fixtures are already purchased - labour only is required. Please quote by the hour. Scope of work: • Replace 9 x power points • Install 2 x additional power points • Replace 7 x light switches • Replace 8 x downlights (4 standard, 2 smart home, 1 fan light) • Replace oven

I have a down light that I am wanting to change to a pendant light

$150 for each job and any extra. Need a downstairs ceiling fan chopped 30 cm so a floating ceiling can be put in on Room. Would also like our house switchboard checked out as it has tripped out a couple of times when coffee machine microwave dishwasher and certain power points are on. It is just one circuit.

Ryobi generator operating till the fuel ran dry. Fuel line may need servicing

2 x 200w renogy shadowflux panels to rhino pioneer 6 platform 2019 hiace brackets allign on outside and front and rear channels but not the inner edges or middle edges

2 x 200w renogy shadowflux panels to rhino pioneer 6 platform 2019 hiace brackets allign on outside and front and rear channels but not the inner edges or middle edges

Old pendant light removal and new light install. Removal and disposal of old light and rubbish.

Looking for quotes on: 3 x ceiling fan installation, will be installed where there are existing ceiling pendant lights, 1 x light switch (for fan + light) installed, 1 x light switch move to other side of a doorway

Replace the old led lights with new ones By 3

My ebike is a home made one, the wiring isn’t great but has been working good. Rode it to work good but then when I tried to get it going again the throttle didn’t work, the throttle would cause a rumbling sound and feeling (jumpy)as though it wasn’t sending through properly. Now the jumping has stopped I can hear it try to send the signal to go but it doesn’t. Seems like a wiring issue

Hi I have a Mercedes sprinter and it has simple electrical system where there are a few lights running off a battery. Would need some help with fixing it. Was running before could just be a connection, etc. If you know something about van electronics I d love your help. Franziska