Find trusted local electricians in Moggill

Have a number of tasks as below: 11 x new downlights to be installed 5 x new light switches to be installed to connect to above lights 11 x double plug points to be installed 1 x garage door switch to be installed 2 x rangehood to be installed and wired up 1 x electric cooktop to be installed ans wired up 1 x Oven to be installed and wired up 1 x gas cooktop related electrical connection The above lot involves using existing wires present in the walls at relevant outlets as well as drawing new wires for new light switches . I would say 30- 40% is new wiring, rest is using existing wire already present in the walls. Also need to figure out some of the wires in the roof that were pulled out by the builder previously and reconnect them so that power can be supplied to the relevant light switches and power points.

The lamp needs rewiring. The switch trips the circuit breaker and the whole electrical cord has to be replaced.

Require electrician to install about 25 led downlights.. can provide lights Existing wiring in place with smaller old lights, just need to make the cut out bigger and connect the new lights to the existing wires

Heat Pump hot water system needs service. Temperature of water getting less hot progressively.

To fit a chandelier in living room and put some additional plug points

Needing two ceiling fans replaced and one installed as there isnt one in the lounge room. And new all new switches

Hi We need our new oven installed ASAP. Easy job. In and out. Must be on site 7:00 am

Run new circuits for 4x aircons - Due date: Needs to be done on Friday, 24 February 2023

Mitsubishi 2.5kw Split aircon (SRK25ZSA-W) from Bunnings. Ready to install. It's at single story property, Brick Veneer, External Wall for indoor component, Back to back configuration (photos attached), On ground with poly slab required for outdoor component. Straightforward installation. - Due date: Flexible

My Gardenline 4 stroke electric start mower stopped working. Looking for someone to help fix the issue. - Due date: Flexible

I need the belt changed on my toro zero turn, pics in photos. The ride on is outside and under cover and parked on concrete. I have the correct replacement belt already. The deck lifts up to aid belt install. Located in Moggill. I am not sure what tools are required so I am not sure if I have what is necessary. Preferably bring everything with you that is needed. It would be great if this task could be done in the next couple of days as the grass is in need of cutting with all this rain :-)

To diamond and hand grind the concrete flooring, then patch if any holes and cracks before rolling the epoxy and flaking into it. scrape the flake, sand and clean before rolling UV stable polyurethane and slip resistance coating. Area 30 sqmeter. Rate expected forty per meter square - Due date: Flexible