Find trusted local electricians in Chelmer

Electrical Repair Needed - Joolca HotTap Repair (Chelmer) Looking for an electrician to repair a Joolca HotTap portable hot water system. Likely a simple issue possibly a loose wire or minor electrical fault. Quick job for someone experienced.

To the HVAC Specialist, I require a quote for the installation and commissioning of a ducted air conditioning zoning system. I have already purchased all the necessary hardware components. Job Scope: * Install Owner-Supplied Hardware: Install motorised zone dampers, fan deck, and associated components for an existing Daikin ducted system. * Connect Ductwork: Connect the system to existing ductwork. The ducting appears to be pre-marked for zones such as "Lounge," "Bed 2," and "Kit/Dine." * Controller & Wiring: Install and wire the new zone controller/thermostat. * Commissioning: Ensure all zones and controls are fully functional. Please provide a quote for labour and any minor sundries required for the installation. Could you please let me know your availability for an on-site inspection? Thank you.

Extend nbn cable to another room about 10m away.

Replace two power points, install a 4 gang power point in kitchen

Replace two double power points in two different rooms, install 1 x4 gang power point downstairs, have to cut through man made wall cladding.

Apologies to those who bid previously, I had to source a replacement towel rail and the task expired. Looking for a qualified electrician to install a PowerPoint, install a heated towel rail (supplied - 750mm wide) in ensuite and install a new exhaust fan (supplied - no existing fan) in ensuite. Good roof and under house access. Wall in ensuite is exterior wall and is VJ Board. Happy for it to be done during daytime or after hours. Not sure what the going rate is so keen to receive your offers.

Hi, I'm hoping to get an aircon installation quote. I have purchased 3 new split units, 2x 7.1kW and 1x 2.5kW. One of the 7.1kW is a switch out for an old 7.1kW Toshiba which went underwater during the 2021 flooding and has not worked since. The other 7.1kW is a ground install in a converted garage/rumpus room The 2.5kW is an upstairs bedroom I have included photos and a floor plan which details the intended positions. If I can get a quote to have the outdoor units wall mounted 2m above ground level to reduce the chance of flooding in the future that would be great, I'm happy to purchase the brackets myself if it will save cost.

We have builders works commencing late next week and require 4 points to be isolated in readiness. These include - 1 GPO, 1 light, 1 smoke detector and 1 light switch. Simple job that shouldn’t take any longer the. Half an hour. We’d like anyone doing the work to at least be a 3rd year apprentice.

I need a hole cut in the shelf for a small IKEA exhaust fan and it attached. Also the oven sits on a metal plate that needs to be lowered approx 3-5ml so the oven can be pushed in properly. - Due date: Needs to be done on Monday, 30 October 2023

Hook up isolator switch to switchboard 1 meter away. Air con guy will come back to switch on test air con. ** extra pictures added - Due date: Flexible

13 x down lights need replacing. Looking for all bulbs to be the same warm light colour. We can supply bulbs or you can. Ceiling is up to 5m high at tallest point, very tall ladder required. - Due date: Before Saturday, 30 September 2023

Looking for a Pre Purchase electrical inspection by a licensed electrician. - Due date: Before Wednesday, 23 August 2023

Need 3x non compliant 240v hard wired smoke alarms replaced - install only I will supply new alarms. 2.4m ceiling height Please do not respond if not licenced electrician in Qld

I need a 10m long trench of 50cm dug for pool electrics. Bring own equipment. In chelmer

Replace the following: - Replace 9 dimmer modules - Replace 2 gangs and 2 switches - Replace security sensor light Just need to swap the existing parts. All parts are provided and all wiring is already in place.