Find trusted local electricians in Camp Hill

Light switch has fallen inside. Was working fine this morning so I think the wiring is fine

10 solar panels on tile roof. All parts on site but require cabling to inverter on same side of house as panels to be installed.

The 10 solar panels have been removed and need to be resited on a terracotta roof by a qualified solar installer

Electrician required to help with various tasks around the house. - Task 1: Hanging/connecting pendant light above dining table. Have bought all parts/pieces - Task 2: Installing 2 x GPOs on the top back wall to hang two rear speakers close to the ceiling. - Task 3: Fixing GPO in main bathroom, top light switch stuck - Task 4: Outside lights turn on with switch inside but not working. We are flex as WFH most of the week.

Licensed electrician needed – add 4 ceiling plug bases for downlights I’m replacing the existing bathroom light/fan unit with four plug-in LED downlights and a separate exhaust fan. The existing light is supplied from a single switched ceiling socket. I need a licensed electrician to: * remove or disconnect the existing single light socket; * extend the existing switched lighting supply; * install four ceiling plug bases/outlets wired in parallel, one for each downlight; * leave the outlets accessible through the downlight or fan openings; * test the completed installation. I already have the four plug-in downlights and the replacement fan. I will: * mark and cut the four downlight holes; * install the downlights; * handle the non-electrical work. There is no roof-space access. Access is through the existing approximately 300 mm fan opening and the four downlight holes. The bathroom is approximately 2.7 m × 1.8 m. Please quote for the electrical wiring and four plug bases only.

Install 7 smoke alarms 1 each for 5 seperate bedrooms and one in hallway for 1st floor and last one at ground floor. Must supply your own interconnected smoke alarms. Must have license and can provide queesland smoke alarm compliance report. We are also a group of property managers so if you do a good job. We can give you a lot more business and jobs.

Need an additional power point installed in a top cupboard in a double storey home in camp hill

Hisense Heat Pump Dryer Series 7. Is taking hours to dry not sure the issues ….everything still works and operates though.

Minor repairs & reattach a privacy screen to the wall & new put up a new fence post. It's roughly 1200 X 2100. It's an old lightweight timber lattice panel that has fallen apart. I have all the equipment, nail gun, liquid nails, screws, cement etc, just need some help as I'm unwell & can't manage it alone.

I need the following done: 1x light switch swapped to new fitting 1x double powerpoint swapped to new fitting 1x double powerpoint swapped to a quad powerpoint 1x induction switch relocated 1x double outdoor point relocated (easily accessible) 1x powerpoint for extractor rangehood relocated (easily accessible) 1x terminate power to external spotlight/camera

Change existing lights to new

Security camera to be installed at back of house. The security camera is “Arlo” and needs to be hardwired. It is also a motion sensor light. We want to install where old flood lights are (to be removed). Second part of job - lights under our home (Queenslander semi built in) need replacing. We currently have fluoroscopy tubes but would like to replace with LED lights. Please contact me to discuss a price. Will be getting a couple of quotes to compare. Thanks!

Must be qualified electrician. Remove old chandelier from ceiling and replace with heavier chandelier. Also need two ceiling exhaust fans fixed.

Remove old electrical wiring, water pipe and any nails/screws from under side of Queenslander ahead of renovation. House has already had electricity and water disconnected.

I need an experienced technician to install a Lincoln Conveyor Oven (Model #25045I2N0001620) and ensure it is set up properly. The unit is equipped with a 30-minute cool-down timer, and I need the technician to follow all instructions and safety guidelines for installation, ensuring proper cooling and electrical connections. Requirements: Ensure the conveyor oven is properly installed and connected to the power supply. Verify the unit operates correctly, including the cooling timer functionality (after power-off cooling system for 30 minutes). Follow safety protocols, including confirming the 240V connection and 25A power supply. Test the oven after installation to make sure everything is working as expected. Please bring any necessary tools and materials required for the installation. If you have experience with similar commercial kitchen equipment or ovens, that would be preferred.

I have a boat that requires some work Terps with rag clean pain and glue Stanley knife Blue touch up paint. Hammer and small nails pin nails Strut on hatch needs fixing Gear oil for the bow thruster Screw driver set Stainless screws Down light in toilet and bathroom don’t work Teiple a battery’s Hold fridge down 1 20 mil sticker on top of window Black paint Electrition Generator service Fix Deisel leak Check battery’s Hook lights up

Need a power point added in one bedroom, and a power point + tv cable moved for a wall-mounted tv

Thermann heat pump water heater. The pressure valves are constantly leaking

We suspect we have an issue with our NBN connection pount as we are experiencing constant drop outs they are resolved by removing and reconnecting the cable between our wall point and our NBN router

Need someone to help install a new ceiling light for my mums birthday. Ceiling height is 300cm