Find a local console repairer in West Melbourne

Shower taps needs to be fixed/replaced. hard to turn off

Scope of Works: * Fill visible gaps between melamine panels. * Fill gaps in skirting boards. * Caulk/seal all visible gaps to provide a neat finished appearance. * Sand and prepare repaired areas ready for painting.

Fill in the gaps between the gaps of the bricks

Requirements: Must have experience with signal conditioning, open-collector logic, and soldering custom harnesses. Must have own tools (multimeter, soldering iron, etc.).

We require the shower head and shower taps (see photo) capped off/removed over bathtub (keeping bath taps and spout as functional).

Replace whole tap sets in wash room and laundry. Replace with 1/2 turn or 1/4 turn taps Labour charge only

I have an old mixer in the basin of my bathrooms and laundry. I need to replace the two separate taps with a single mixer that combines both hot and cold water. I do not need to replace the basin. I just need to replace the taps. Two bathrooms and one laundry. I will supply the mixers. Let me know which ones will work and I will buy them. I only need this done without changing the basin- I am not looking to change the whole thing.

I’m looking to have a 32-amp EV charger circuit installed in my garage. I have a three-phase power supply at home.

Looking for a plumber to lift bath taps 200mm to suit a freestanding bath conversion.

Access is only through front door so needs to be a have held machine but stumps are small to medium. The photos of the stumps are not taking well so I have put up photos of trees but these have all been cut to ankle height.

Fix 3 x Leaky Twin-Handle Mixer Taps (Bathroom) Hi there, I need a qualified plumber or experienced handyman to change the rubber washer for three leaky taps in my main bathroom. All three are traditional twin-handle mixer taps (separate hot and cold handles, but a single shared spout/outlet). The 3 locations are: 1 Bathroom wash basin tap 1 Bathtub tap 1 Shower tap

Need done on Monday 18/5 (Today) Lower my laundry taps to be under benchtop, you’ll need to supply a new noggin and new taps that are slim to the wall to fit my washing machine/dryer in front of them. Please also supply the right fittings/crimps to the pipework no push fittings. Happy for Plukber to make a hole I’ll get it patched up later.

Replace the current tap with a new tap

Hello I'm looking for a plumber to swap 2 taps, kitchen tab & laundry room tap. Oddly, my previous job post disappeared. Please ref to images. Location Manor Lakes Victoria 3024.

I have 2 lamps that have to be installed on the ceiling and the electrical connection has to be made through the lights that are already in place

Need help replacing laundry taps which is leaking. Work to be done Saturday afternoon See photos

When the hot and cold taps are fully turned off the shower head still leaks hot water. Suspect a washer requires replacement, but requires route cause analysis and resolution

My washing machine is in place I just need it connected to the taps

Looking for quote to install electric wall socket/ power points 10amps just below the switch board shown on the pictures.

Two of the bathroom taps needs to be put on properly again it’s not turning properly to turn on and off the water