50 Circuit Board Repair Experts in QLD

I have a VEO camera which has is not charging due to the charging port coming away from the circuit board. I am looking for someone to take it apart and see if it can be fixed.

After cyclone, the power was cut off to all ceiling lights and fans, and it's RCB safety switch trips even after all points are turned off. There is no issues with power sockets or Aircons etc, they are running ok.

My Dad’s power has been off for 4 days. Lights still work but plugs will not work. Safety switch will not turn on despite everything in house has been switched off.

Hi i have a power supply unit to a drone which requires a backup battery. I need someone to design and makeup something that will A) ensure no charge from the powerunit goes into the backup battery B) should the power supply unit fail ensure that the backup battery kicks in. I would also require the components to be soldered in to place Any help with this would be much appreciated

The battery terminals on a Garmin Fenix 5X have detached when changing the battery. The soldering is at a fraction-of-a-millimeter scale. I am able to present the watch disassembled so that only the soldering is required, and no further dis/assembly. the attached image shows the location of the +ve/-ve terminals in the yellow circle. I would prefer the work to be done locally (Mackay, 4740)

PCB circuit board does not turn on

Incorrect molex connector used. Beleive it has fried the 12v -5 diode on circuit board.

PCB board on AC unit damaged need testing and compounants replaced

The AC button can’t be pushed up

Microwave remains running when turned off, we have googled to see it is likely a circuit board failure

Control box for a standing desk stopped working - from the photos you can see a component has blown out. Ascot 4007 or if you are close I can bring the PCB to you.

The Contgactor is noisy and needs to be replaced. The task is to replace Contactor in appropriately sized enclosure. Strip and terminate corresponding cable. Loom and tidy cable. Test and commission.

I am looking to restore a vintage Sansui AU-20000 integrated amplifier. Two driver boards have been burnt namely boards F-2507 and F-2507-1. Can they be repaired? 2507-1 is also missing a heatsink bracket. Can this be engineered or reproduced? Would love to discuss further and what a reasonable price would be.

We are installing a spa pool and lightning in our outdoor patio and need a qualified electrician to run cable and install a multi circuit board and power to the spa pool. The spa itself needs a dedicated 20amp circuit. Circuit board is approximately 20 meters from the house, a trench has already been dug.

Need a 2 pin connector replaced on circuit board.

Needs a burnt out part replaced

Need small circuit board capacitor tested & replaced if faulty

the circuit board for a CSB15 pa speaker suffered water damage and doesn't work

I have 2 microcurrent machine ( called Alpha Stim ) which have stopped working and I was wondering if the ir was something in the ]board that had failed . I have 2 in fact that have failed. Is that something you’d could look at to see if you could fix. If a provide photos if you are interested . Thank you very much . Ian harris

A TOP246P has blown on a washing machine circuit board. Needing a replacement and installation of part to circuit board plz