Find experienced local carpenters in Green Point

Needing a timber plinth built for a pump enclosure from H3-70x45mm (laying flat) 1120x2750mm outside dimensions. - Small corner gussets can be used - Please supply timber and screws and tools. - There is a drop saw on site if required. - notched section required for cables to pass under

I need an access hatch built in the rear wooden deck to enable plumbers to access the storm water pipes underneath. The hatch needs to be big enough for a male adult to climb through when open, and safe for people to walk on when closed. I can provide the wood for building the hatch frame.

Hi! I’m looking for someone experienced in bathroom surface refinishing to help restore a bathtub and shower floor that currently have rust stains and a pretty tired look. We’d love to give them a fresh new finish without a full replacement. What Needs Doing: • Properly clean and prep a stained bathtub and shower floor • Remove or treat visible rust marks • Apply a fresh coating to refinish the surfaces and make them look clean and new again Ideally You: • Have experience with bath/shower resurfacing or refinishing • Come with your own tools and materials (paints, primers, sealants etc.) • Can deliver a smooth, durable, and professional finish If You Don’t Have Materials: That’s okay – I’m happy to grab whatever’s needed from Bunnings if you can provide a list beforehand. Location: GreenPoint NSW When: Flexible, but sooner the better Budget: Open to reasonable offers – let me know what you’d charge

Replacement of the IKEA kitchen cupboard doors, a few panels and trims (material supplied, needs own tools) Removal and disposal of old material Must have an ABN and provide a quote. Mid - late November

The stairs are old and need replacing.

I need someone with carpentry skills or tools to sand down or cut part of my cabinet trim in my laundry room. We recently purchased a new washer/dryer that is slightly too tall (even though it’s the same measurements as our old one). - Due date: Flexible

Want to turn living area into another bedroom. Need carpenter frame up and stud work to suit 820 door. Approx 870 x 2070. Will also require small amount of gyprock. Image is area provide. Total space 1100 x 2900 - Due date: Before Friday, 30 September 2022

I need to a cabinet maker or carpenter to pick up a bench top from bunnings and install bench top. The existing bench top will need to be removed and disposed. A hole will need to be cut for a sink

I need carpenter to cut the bottom of 1 doors. Cut approx 5mm of the bottom of the door to allow for tiling. Job is situated in Waterloo

Replace door frame with similar coloured wood. Job is urgent and located in Green Point. I don’t have materials - send me offers for completion including materials.