Find a professional bricklayer in East Melbourne

Brick cutter needed to cut vertical single skin brick wall. Approx 2 metre tall easy access. No clean up required $ 200 job ready in Surrey hills.

Need renovation layout + interior direction for a 4-bedroom house in Balwyn. Including 2 ensuites layout, lighting suggestion and material palette. Not full service, design only.

Brick wall damage by car And this needs to be fixed properly as soon as possible before the rain comes on Sunday. Not enough spare bricks to cover all the broken ones. Please send me quotes roughly. Thanks

4 No. vertical brick cuts through 10mm brickwork. 2x2100mm. 2x2400mm

Need to cut brick/tile to create a path for water to drain. Allow drilling up to 8 weep holes. Use level to work our levels properly . The tiles has been laid so that the fall goes towards the corner of brick, water is pooling there.

I’m looking for a bricklayer for a small front stair project in Surrey Hills. Scope: New build (not repair) 3 brick steps (total rise ~500mm, ~167mm each) Stair width ~1800mm (with slightly wider bottom step if possible) Full concrete footing required (100–150mm with mesh) Top step will be timber (done by deck builder), so brickwork to finish just below Details: Tread depth ~285mm (bottom ~300mm) Standard brick finish (open to matching existing house brick or suitable alternative) Located at front porch (easy access) I can share a drawing/spec if helpful. Could you please provide: Rough quote Availability Whether you handle footing as well

Job Title: Brick Patching Job Description: A hole was created in a brick wall by an air conditioning installer during a previous installation. The unit has since been relocated, and the opening now needs to be repaired. The job involves: - Patching and restoring the external brick wall to match the existing structure as closely as possible Additional Notes: - Please bring all necessary materials and tools - Experience with brickwork is required - Clean workmanship and proper finishing are important Please provide a quote and estimated timeframe for completion.

Four bricks need to be relayed into a wall from which they have been removed

To remove old air vent and brick 2 pieces of brick to cover the hole

Repair an external brick wall which has been knocked off and repair to original position. About 75cm high.

Mortar is eroding at base of wall and bricks are cracking due to fence being installed. Job is to repoint and fix the wall - adhere the cracked bricks if possible.

Add 3m x 36cm of brick wall to existing wall. Bricks supplied

I’m doing a renovation on my kitchen and the brick wall has been damaged. Will need to get it patched up to make it even, just the top half around 200mm down from the window sill, so the splashback can be installed. It doesn’t need to look pretty as it’ll be covered.

IN-PERSON QUOTE ONLY at this stage - needed for brick wall repair - it is difficult to see the full extent of the cracking in the attached photos. Experienced bricklayers only - must be friendly, reliable, clean and tidy and able to work without loud music.

Bricks relaid on level ground

Hi, I’m looking for an experienced bricklayer to help rebuild the brickwork under my window. Please refer to the photos: • The first two photos show the original bricks that were removed — these can be reused. • The third photo shows an area where extra bricks are needed because some bricks cannot be reused. Job details: • Reinstall the existing removed bricks • Supply and install additional bricks OR I can supply the bricks myself • Match brick type and mortar colour as closely as possible • Clean and tidy finish

this building is a block of units Some of the mortar has gone between the bricks and in need of pinning and alining I feel this would need someone experiences in brick laying. Are you this person or do you know someone who is? You would need to look at the job and quote before starting as it would need to be committee approved

Bricks need to be repointed in a unit block. Some support work A quote is need. A few photos attached

I Need this bricked up pls I have the brick You need to supply some white Bricky sand to match mortar Thanks

1 x wall requires brick stitching to repair cracks, approx 1.7m high. Crack stitch wires supplied by me to be embedded in 4 courses and all beds and peeps to be filled neatly. Install 1 x expansion joint in at brick expansion to be tided with mortar on right side splits.