Find experienced auto electricians in NSW

I would like the following installed into my 2020 Kia stinger gt, I have a Rockville DB14 monoblock, Aerpro APHL2MI LOC, and amp wiring kit to power my dual 12 alpine type r’s , The battery is in the boot and same as the factory amplifier as the car has harmon kardon sound system,

Also, advise if we include a second car as well, which is Mazda CX-5, how much would that be in total?

I have a box trailer, lights run ok but when a blinker is turned on, the other lights flash with the blinker. I think it’s an earth issue because the white earth cable isn’t connected to anything. I think I need someone to get the white cable out and connect it somewhere along the trailer frame.

Hello! Looking for someone experienced with car audio/interior trim to finish installing an Apple CarPlay/Android Auto retrofit kit into my 2017 Mazda 3 GT. Already completed: • MZD Connect software successfully updated to v70 • Upper dashboard trim removed • Factory screen/CMU removed and wiring disconnected • Battery negative disconnected • Car is currently left disassembled at this stage Parts: I have the complete retrofit kit including the new USB/SD hub, cabling and trim-removal tools. Work remaining: • Remove the original USB/SD/AUX hub located below the climate controls (preferably without damaging it) • Install the new CarPlay USB hub and cabling • Reconnect/test the CMU and CarPlay • Reassemble the dashboard/centre console Ideally looking for someone with experience installing Mazda MZD Connect / OEM-style CarPlay retrofit kits, or similar car audio/trim experience.

Power isn’t running to my inverter. When I turn on my fridge, it has a low voltage warning indicator. Battery shows full, not sure what has changed. Was working a few weeks ago, not sure what has changed.

Car stopped working. Mechanic has looked at it. Needing an auto electrician to check what's wrong.

My after market rear camera needs to be extended and the light below the number plate needs fixing. Looking for an auto electrician so can fix.

Looking for an auto electrician, caravan repairer, or knowledgeable 12V handyperson to fix the internal 12V light circuit on my Windsor Rapid caravan, parked in my driveway in Lambton. Primary Task: Fix the 12V Light Circuit: Get the internal lights working again. I was disconnecting a fan/light unit and the internal lights went out right after. I suspect a bare wire touched, causing a short circuit and blowing the fuse. Secondary Tasks: Locate the Fuse Panel: Find the internal 12V fuse box/power management unit on this van and swap the blown fuse. Insulate Wires: Properly cap and insulate the bare/disconnected wires so the circuit doesn't short out again. Verify: Test the circuit to ensure all lights are powered and working safely. Location: Driveway in Lambton (Newcastle)

my brake lights are stuck on now my battery is flat. Single Mum needs some assistance.

I’m attempting to wire up new headlight, Speedo, odometer, indicators and tailight on a 2006 Yamaha TW200. Need some assistance!

I need to get car head unit installed into my Lancer T-eye CC4L Car head unit

I need alternator fitted to my 2012 range rover evoque. I have the part ready just need someone with mechanical skills to install it, has to be done anytime friday during the day. Must have your own tools. Location Lurnea

Auto Electrician or Automotive Trade / Apprentice with knowledge of 80’s & 90’s euro vehicles. Job requires accessing, cleaning contacts and relays and/or replacing sections of engine bay wiring/terminals/contacts etc. Everything is in working order just wishing to improve appearance and avoid further issue of brittle 30yr wiring or perished rubber and plastic. Take out and swap in new sections immediately. All materials will be supplied unless you have a better option I’ve not adequately considered. Please quote per hour. Many thanks

Need dash cam installation at 5

Toyota Hiace 2006 needs to have new android head unit installed. I have the head unit but because there was already an aftermarket head unit fitted, i cant plug and play using the factory harness as its been re wired to suit the previous head unit. I need someone with understanding of auto electronics to make it work.

Hi there! Need a dash cam installed in my triton dual cab 2009. Front and rear. I already got the cameras and wiring.

I’m looking for someone able to replace the right side fender of my Ute. I have the new fender.

Rewiring of a bunch of 12v circuits on multiple vehicles and plant General 12v work, no license required ongoing weekly work available

We need dash camera installed ( front is already installed) + rear view canera. Hard wire kit pre-fit in the car, only need to get it wired with new cam. Camera model - Nexus N5S Vantrue Car model- Ford mustang

Auto Electrician Needed – Install Rear Canopy Lights & Check DC-DC Charger Wiring I've recently fitted a new tradesman 4x4 canopy to MR Triton and need the rear LED lights wired up and installed. It looks like a fairly straightforward job, but I'd prefer someone experienced to do it properly. Manual says like hour jib so sure you could smash it out quickly While you're here, I'd also like you to have a look at the wiring for my DC-DC charger. It stopped charging the auxiliary battery after I changed the Anderson plug, so I'm guessing I've done something wrong and would appreciate someone diagnosing and fixing it. Looking for someone with auto electrical experience who has their own tools. Located at Edgeworth Please let me know your experience, availability, and quote. Thanks! 🚙🔧