Power Point Installation Jobs in Inner South Melbourne

Browse through over 500 Power Point Installation Jobs.

See what you could earn

$0

per month

Based on average power point installation task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Power Point Installation tasks in Inner South Melbourne

Check out what tasks people want done near you right now...

Looking for a fully licensed electrician to supply and install two brand new standard double power points in my home. Job Details: Power Point 1: To be installed in the entryway. Power Point 2: To be installed in the spare room. Wall Type: Both rooms have standard plasterboard walls with hollow cavities. Wiring: There are existing power points nearby in both areas that should be suitable to loop/piggyback off. Requirements: Must be a fully licensed electrician (please provide your license number when bidding or upon arrival). Please include the cost of standard white double faceplates and all materials in your quote. Must be able to provide a Certificate of Electrical Safety upon completion. Flexible with days and times for the right person. Thank you! Also looking for the electrician to mount a small 32" TV to the plasterboard wall while on site (I will supply the TV and the full-motion wall bracket)- for an extra $40

Dandenong VIC 3175, Australia

Sun Jun 14 2026

about 3 hours ago

Open

Supply and install a mechanical exhaust fan through the existing bathroom window. Scope: * Inspect existing bathroom window and confirm suitability. * Remove and replace glass panel as required to accommodate fan. * Supply and install 200 mm exhaust fan with external weatherproof grille and backdraft damper. * Connect fan to power supply and switch (or integrate with light switch subject to electrician’s recommendation). * Seal all penetrations and make good surrounding finishes. * Test and commission system to ensure effective operation. Performance Requirement: * Fan to provide adequate extraction for bathroom moisture control. * Low-noise operation preferred. * Installation to comply with all relevant electrical and building requirements.

Toorak VIC, Australia

Sun Jun 14 2026

about 4 hours ago

Open

All lights are supplied except downlights Need an electrician to do below tasks 3 pendant light in kitchen 2 Pendant light in powder room 6 outdoor lights on facade pillars 4 wall lights in Bathrooms Around 28 down-lights on upstairs (have existing point just add a downlights to same switch and wire ) All pendant/ wall/ exterior lights have existing points and no extra wiring is needed

Rowville VIC 3178, Australia

Sun Jun 14 2026

about 5 hours ago

Open

Hi, I need a licensed electrician for a few jobs at my home. The work required: 1. Outdoor power point for inflatable spa * I have an existing outdoor power outlet near where I’ll be placing an inflatable hot tub. * The outlet works, but it does not appear to be weatherproof, so I don’t want to use it as-is. * I need you to inspect the existing socket and wiring. * Confirm the circuit is safe and suitable for an inflatable spa/hot tub. * Confirm proper RCD/safety switch protection. * install a compliant weatherproof outdoor GPO suitable for direct plug-in use with the spa. 2. Power point inside wardrobe * Install a new power point inside a wardrobe. 3. Kitchen wall sconce and dimmer switch * Install a wall sconce/light fitting in the kitchen. * Install a new compatible dimmer switch for it. Important: * I only want a licensed electrician. * Please only respond if you can provide the required Certificate of Electrical Safety after completing the work. Please submit offers

Brighton East VIC, Australia

Sat Jun 13 2026

1 day ago

Open

Need to add a power point - double GPO - experienced electrician please with certificate to be provided at completion

Mount Waverley VIC, Australia

Sat Jun 13 2026

1 day ago

Open

Need a Power Point behind the TV and an aerial port and connection to roof aerial

Cheltenham VIC, Australia

Sat Jun 13 2026

1 day ago

Open

Look for advice, re apprenticeship

Fri Jun 12 2026

2 days ago

Open

The Glow Strap requires a compact, lightweight and rechargeable electronic system capable of controlling three distinct lighting modes. The device will be worn primarily on the arm but should also be suitable for the wrist or ankle. The circuit must incorporate a rechargeable 3.7V lithium-polymer (Li-Po) battery with integrated protection against overcharging, over-discharging and short circuits. Charging should occur via a USB-C port to ensure ease of use and compatibility with modern charging devices. The lighting system must provide three user-selectable modes: Mode Colour Operation Mode 1-Orange- Slow flash every 2–3 seconds Mode 2- Red- Fast flash every 0.5 seconds Mode 3- White- Continuous illumination The circuit should include three tactile buttons, each dedicated to activating one lighting mode. An additional power button may be incorporated if required. Only one mode should operate at a time, with selection of a new mode automatically disabling the previous mode. A microcontroller should be used to control timing sequences, button inputs and power management. The circuit should be designed to maximise battery life while maintaining high visibility. The lighting system must be bright enough to be clearly visible from a minimum distance of 20 metres in low-light conditions. The engineer may utilise individual LEDs, RGB LEDs or RGBW LEDs provided the required colours and brightness levels are achieved. The complete electronic assembly must remain compact enough to fit within a wearable enclosure approximately 80 mm × 60 mm × 20 mm. The system should also be resistant to vibration, sweat and light rain, ensuring reliable outdoor operation. The final deliverables should include a circuit schematic, PCB layout, component list, programmed code and battery life calculations. If there are any other details or specifications you need, let me know

Fri Jun 12 2026

2 days ago

Open

Need a licensed electrician to install a TCP Smart 2000W Downflow Bathroom Heater above a bathroom door. Scope: • Supply and install heater (heater provided) • Mount above bathroom doorway in accordance with manufacturer requirements • Connect to existing power supply or advise if additional wiring is required • Test operation and ensure safe installation Please quote if additional wiring or electrical work is required.

Bentleigh VIC, Australia

Thu Jun 11 2026

3 days ago

Open

Browse all tasks

Last updated on 14th Jun 2026

Discover your earning potential in Inner South Melbourne

Earn money with every power point installation task

$418

per week

1-2 tasks per week

$1,045

per week

3-5 tasks per week

$1,463+

per week

5+ tasks per week

$1,810

per month

1-2 tasks per week

$4,525

per month

3-5 tasks per week

$6,335+

per month

5+ tasks per week

$21,736

per year

1-2 tasks per week

$54,340

per year

3-5 tasks per week

$76,076+

per year

5+ tasks per week

*Based on average power point installation task prices in Inner South Melbourne. Actual marketplace earnings may vary

Join Airtasker

Unlock new income opportunities in Inner South Melbourne

Explore power point installation related jobs and discover your financial opportunities

Type of power point installation job	1-2 tasks/week	3-5 tasks/week	5+ tasks/week
Electricians	$400	$1,000	$1,400
Downlights Installation	$400	$1,000	$1,400
Power Point Installation	$418	$1,045	$1,463
Sockets and Switches Installation	$400	$1,000	$1,400
Smoke Alarm Installation	$280	$700	$980
NBN Electrician	$320	$800	$1,120
Light Installation	$490	$1,225	$1,715
Solar Panel Installation	$294	$735	$1,029
Water Heater Repairs and Installation	$500	$1,250	$1,750
Electrical Rewiring	$300	$750	$1,050

*Based on average power point installation task prices in Inner South Melbourne. Actual marketplace earnings may vary

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

Get Inspired: Top Power Point Installation Taskers in Inner South Melbourne

meet
Matthew P
10 years on Airtasker
- Richmond VIC
5
Overall rating
962 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
1089 tasks
meet
Jayson M
9 years on Airtasker
- Seaford VIC
5
Overall rating
66 reviews
98.68%
Completion rate
The percentage of tasks successfully completed by the Tasker
76 tasks
meet
Tugrul O
8 years on Airtasker
- Melbourne City CBD VIC
5
Overall rating
149 reviews
98.4%
Completion rate
The percentage of tasks successfully completed by the Tasker
187 tasks
meet
Baz A
7 years on Airtasker
- Hallam VIC
4.9
Overall rating
745 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
866 tasks
meet
Anastasios G
6 years on Airtasker
- Heidelberg Heights VIC
5
Overall rating
7 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
7 tasks
meet
Brayden H
1 year on Airtasker
- Mernda VIC
5
Overall rating
104 reviews
99.25%
Completion rate
The percentage of tasks successfully completed by the Tasker
134 tasks
meet
Giuseppe V
1 year on Airtasker
- Hawthorn VIC
5
Overall rating
75 reviews
98.95%
Completion rate
The percentage of tasks successfully completed by the Tasker
95 tasks
meet
Mcken T
5 months on Airtasker
- Bonnie Brook VIC
5
Overall rating
137 reviews
97.67%
Completion rate
The percentage of tasks successfully completed by the Tasker
172 tasks