Amplifier Repair Jobs near you

Browse through over 500 Amplifier Repair Jobs.

See what you could earn

$0

per month

Based on average amplifier repair task prices. Actual marketplace earnings may vary

Why join Airtasker

Join Airtasker

Amplifier Repair tasks in Australia

Check out what tasks people want done near you right now...

Renovation of Two Bedrooms (26 m² Total) – Ceiling, Flooring and Plaster Repairs Looking for an experienced handyman or renovation tradesperson to renovate and prepare two bedrooms, approximately 26 m² combined, for new carpet, wardrobes and painting. Scope of work: 1. Ceilings: Install new smooth plasterboard ceilings over the existing ceilings including jointing, plastering and sanding to achieve a final finish. 2. Wardrobe removal: Remove and dispose of existing 3. Carpet removal: Remove and dispose of existing carpet and underlay in both bedrooms. 4. Timber floor repairs: Inspect and fix squeaky or noisy timber floorboards before new carpet installation. 5. Plaster repairs: Patch and repair walls, ceiling edges and damaged areas, 6. Door frames and trims: Carry out minor repairs or adjustments where required. 7. Final preparation: Complete all filling, sanding and finishing to leave both rooms ready for painting, carpet installation and new wardrobes. Photos of the existing rooms are attached. Please provide an estimated quote, availability and experience with similar work. The quote should include labour, materials and rubbish removal. Note: New carpet installation, wardrobe installation and painting are excluded from this job. Electrician may required. Location: Mitcham

Mitcham VIC 3132, Australia

Sat Oct 24 2026

11 minutes ago

Open

Looking for someone experienced with older brick walls to refit a curtain rod and rehang the curtain tomorrow, Sunday 25 October, in Vaucluse. The building is about 80 years old. The wall plugs have pulled out, leaving enlarged holes and crumbling brick. I tried Ramset UltraFix, but it didn't hold. Please assess the wall and securely refit the brackets, using fresh fixing positions or another suitable method. I'd also like all brackets supporting this rod checked, and the old holes filled, smoothed and left ready for painting. Please clean up the drilling dust and debris afterwards. The curtain, rod and existing brackets are supplied. Please bring your own tools, masonry drill and bits, ladder, suitable fixings and filling materials. Please include labour, standard fixings and hole patching in your offer. If replacement brackets, a mounting board or other materials are needed, please let me know upfront and include any extra cost. Please include your availability tomorrow and how you'd approach the repair. Experience with older brick walls preferred.

Vaucluse NSW 2030, Australia

Sat Oct 24 2026

14 minutes ago

Open

Need screeding f(lush finishing) a wall repair The walls have been scraped for moisture membrane in 3 sections Approx 2 m2 each, so 6 m2 in total Need plaster finishing to enable flush surface (approx 1-2mm thick) No need to seal or paint, Plaster screeding with a float or large plaster knife so that the finished surface is even with flush edges and smooth sanding

Darlinghurst NSW 2010, Australia

Sat Oct 24 2026

15 minutes ago

Open

> Appliance: Fisher & Paykel ActiveSmart Refrigerator > Model: E521T (Product Code: 21538-A) > Issue Details: > The fridge and freezer are cooling perfectly fine and holding proper temperatures (actually it’s too cold!). However: > * The interior light inside the cabinet does not turn on when the door is opened. > * The temperature control buttons / user display panel inside are completely unresponsive and won't adjust. > * Hard power resets (power cycling for 5+ mins) and Sabbath Mode toggle attempts have not resolved it. > Requirements: > * Experienced appliance repair technician / electrician. > * It may require replacement user interface PCB, LED lamp module circuit, or door switch relay. Bonus if you have spare parts for E521T Diagnostic things I’ve tried: 1. passing a magnet over light sensor but it didn’t do anything. 2.power off 5 minutes Didn’t help.

Brighton VIC 3186, Australia

Sat Oct 24 2026

25 minutes ago

Open

We’re looking for a qualified electrician to diagnose and repair an issue with our oven that is repeatedly causing the circuit breaker to trip.

Pimpama QLD 4209, Australia

Sat Oct 24 2026

28 minutes ago

Open

Hi need panel repair to 2024 Ford Ranger 2 areas

Park Orchards VIC 3114, Australia

Sat Oct 24 2026

31 minutes ago

Open

I want someone to replace all the damage parts of my car.

Tusmore SA 5065, Australia

Sat Oct 24 2026

34 minutes ago

Open

Task Title: Roller Shutter Repair – Stuck and Won't Close Description: I need someone to fix an exterior roller shutter on a window. The shutter is currently stuck. It will not close at all when using the wall switch.

Derrimut VIC 3026, Australia

Sat Oct 24 2026

about 1 hour ago

Open

Handyman Required – Install 2 Door Seals & Repair Bathroom Door Looking for an experienced handyman to complete two jobs at my home. All materials have already been purchased and will be supplied. Please quote for labour and bring your own tools. Job 1 – Install 2 Automatic Door Bottom Seals * Install one automatic drop-down seal on my front timber entry door and one on my backyard timber entry door. * Both are standard-sized hinged timber doors that open inwards. Each has a separate security door that opens outwards. * The purpose is to seal gaps underneath the timber doors and prevent earwigs and other crawling insects entering the house. * Measure and neatly trim the seals to fit if required. * Check the mounting position and clearance between the timber and security doors before installation. There is more than 2cm clearance between the closed doors. * Ensure the seals automatically lower against the threshold when closed and lift when opened, without scraping or interfering with either door. * Check that no gaps remain at the bottom corners and be mindful of the cable near the backyard doorway. * Both timber and security doors currently close and lock correctly. They must continue to operate normally after installation. Job 2 – Repair Bathroom Door * The bathroom door will not close completely, even when the handle is held down, and cannot latch or lock properly. * Inspect the hinges, hinge screws, screw holes, door alignment, frame, latch and strike plate to determine the cause. * Carry out necessary adjustments or repairs, including realigning the door, securing hinges or repairing stripped screw holes if required. * Replace any damaged components only if necessary. * Ensure the bathroom door closes smoothly and the handle, latch and privacy lock function correctly. * Avoid unnecessary cutting or planing of the door. Materials & Requirements All purchased materials will be supplied. Please bring the necessary tools and equipment. Photos attached.

Campbellfield VIC 3061, Australia

Sat Oct 24 2026

about 1 hour ago

Open

Browse all tasks

Last updated on 24th Oct 2026

Discover your earning potential in Australia

Earn money with every amplifier repair task

$300

per week

1-2 tasks per week

$750

per week

3-5 tasks per week

$1,050+

per week

5+ tasks per week

$1,299

per month

1-2 tasks per week

$3,248

per month

3-5 tasks per week

$4,547+

per month

5+ tasks per week

$15,600

per year

1-2 tasks per week

$39,000

per year

3-5 tasks per week

$54,600+

per year

5+ tasks per week

*Based on average amplifier repair task prices in Australia. Actual marketplace earnings may vary

Join Airtasker

Unlock new income opportunities in Australia

Explore amplifier repair related jobs and discover your financial opportunities

Type of amplifier repair job	1-2 tasks/week	3-5 tasks/week	5+ tasks/week
Electronic Repair	$418	$1,045	$1,463
Console Repair	$420	$1,050	$1,470
Amplifier Repair	$300	$750	$1,050
Circuit Board Repair	$288	$720	$1,008
Headphone Repair	$140	$350	$490
Drone Repair	$270	$675	$945
Tablet Repair	$294	$735	$1,029
GHD Repair	$150	$375	$525
Speaker Repair	$252	$630	$882
LCD Screen Repair	$530	$1,325	$1,855

*Based on average amplifier repair task prices in Australia. Actual marketplace earnings may vary

How to earn money on Airtasker

Job opportunities that find you

Set up notifications and be alerted when a nearby, well-matched job is posted. Let customers book you directly by setting up a listing. Provide a great service and work with them again with Contacts.

Set your price

Found a job you’re up for? Set your price and make an offer. You can adjust and discuss it later if you need to.

Work. Get paid. Quickly.

When tasks are complete, request for payment to be released and money will appear in your account instantly.

Post a task

Get Inspired: Top Amplifier Repair Taskers in Australia

meet
Kirk W
9 years on Airtasker
- Ipswich QLD
5
Overall rating
228 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
254 tasks
meet
Yahya A
6 years on Airtasker
- Belmore NSW
5
Overall rating
411 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
442 tasks
meet
Fabien B
5 years on Airtasker
- Holland Park West QLD
5
Overall rating
344 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
358 tasks
meet
Collins A
2 years on Airtasker
- Seven Hills NSW
4.9
Overall rating
220 reviews
97.42%
Completion rate
The percentage of tasks successfully completed by the Tasker
271 tasks
meet
Marlon G
2 years on Airtasker
- Melbourne City CBD VIC
4.9
Overall rating
196 reviews
95.69%
Completion rate
The percentage of tasks successfully completed by the Tasker
255 tasks
meet
Kevin T
1 year on Airtasker
- Mount Pritchard NSW
5
Overall rating
18 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
27 tasks
meet
Sehanya dimithri piyathissa D
1 year on Airtasker
- Doncaster VIC
5
Overall rating
46 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
62 tasks
meet
Clement L
3 months on Airtasker
- Underwood QLD
4.7
Overall rating
16 reviews
100%
Completion rate
The percentage of tasks successfully completed by the Tasker
17 tasks