Find a professional garage door installer in South East Melbourne

Hi, please see photo, it is tilted at bottom part.

Steel like garage door remote programming and checking the motor is working.

Philly system needs to be adjusted/ repaired

Hi, I would like to get some quotes on garage door dent repair or if the whole thing needs to be replaced. Dent from backing into it by a car, on the inside bolt/rolly part is crooked and when it's windy its very loud because garage door is not closed fully. Hoping to get it done before new renters move in on Monday.

We have a factory in Cranbourne West that we rent. The real estate has requested we get a service done on the roller door. There is nothing wrong with it just what they have requested. We need a letter saying it has been serviced. Can you help me? Need it done asap please.

The Garage door seal has come off.

Help troubleshoot and fix garage door problem

Garage door cannot open; motor works; cannot manually open after pulling the red cord; spring broken

The garage door sometimes only opens half, may require service

Garage door jammed , and stuck it's broken and hit by car, need to be fixed

The little black springs from my garage door has been disconnected and come off. I need someone to help me put it all back in so the garage door is intact.

Steel line ol4 garage door motor and mechanism. Manual release mechanism cracked and broken. Needs replacement part including red pull cord Supply parts and install

Garage door was working a few days ago, but now it only moves slightly before stopping. Appears to be stuck. Car was backed up to the garage door causing a dent. Could possibly need replacement but need someone to come in to check if that can be avoided.

Hi… my garage roller door opens only half way and gets stuck. While closing door again, it touches the ground and comes back half-way up again. The circular ring piece attached to the left side of garage door ( pic above) came off… Due to this reason, the door not getting rolled up in smaller circular motion and getting stuck in between.

Garage door remote not working properly Takes time New remote replaced same problem

Need to fix garage door roller issue

My garage door has been slightly hit by car and now one of the panels is bent. Because of this, the door won’t fully close. I need someone experienced with garage doors to come and check it, straighten/repair the bent section, and get the door closing properly again.

Garage door will go down then come back up by itself

As per photos current door is falling apart so need someone to Supply and Install Primed Door (including installation of door handle with key locks - you'll need to supply but happy to use existing locks from the old door if that will work). It is the side door entry to my garage. Not sure how much it will cost so give me a quote. Looking for a cheap solution / option for a door that I rarely use and do not care about it aestethically. Measurements: Approx 82.5 x 204.5 x 3.5cm Location: Dandenong North

Install a Orion grid connect DIY garage door controller for me