Find professional window and door services in Hunter Valley

Need garage roller door installed to new shed.

Two holes fixed on old pantry door. They are abit bigger than a 50 cent piece.

The motor fell off the side of the roller door and I think the spring has recoiled. It's currently closed and can't open

Need supply and install new sliding glass door with security screen. 1200w x 2100h

Fix door frame and holes in walls

Need elevator doors wrapped. Vinyl is provided.

The garage needs to be recalibrated

I got a wooden spoon stuck in the sliding door jamb. Need someone to get it out please! Not sure of cost, just let me know your estimate?

The garage door has a minor cosmetic dent on one of the lower metal panels. The dent is shallow and localized, with no sharp creases or cracks visible in the steel. The garage door: • Opens and closes normally • Is not misaligned • Has no structural damage The damage appears to be cosmetic only, mainly affecting the appearance. A repair involving dent reshaping and surface refinishing / repainting should be sufficient. Panel replacement is not required.

I need to improve the ventilation under my house and one way I'm going to do this is by replacing the current wooden door with a door that is a steel grate. This way it will keep dogs out but allow more air through. I need someone to construct the new door from steel and install it. I would like the current hinges and latch to be reused because I would rather not have more holes drilled into the brick work. I would like the squares in the new mesh to be a 50 x 50mm. I'm thinking that you would have to weld a steel frame to put the mesh on but I'm open to other solution that do not involve welding so let me know your ideas and solutions. I have included a picture of the door. I have included a picture of the mesh I was thinking but I'm open to other meshes as long as it would keep out small dogs. Please ask if you have any questions.

I have 2 sliding doors that won’t work, 1 is a double wooden sliding door, and the other is a single sliding door. I think they both just need new rollers and guides but I’m unable to do it

At my investment property the back sliding door need to be repaired or replaced As it not being able to be locked If your able to give me a rough quote or go out and inspect it we can go from there

I have a large window decal that needs installing. (Interior decal). Window signage is 1500mm (height) x 900mm (wide).

One ripped flyscreen replacement

Cut down the width of my roller door security screen

The door needs to be reattached as it as come off

I need someone to replace my existing laundry door that’s got water damage on its exterior, and install a new door that’s I’ve already purchased. It’s previously been used in a house, so the hinge locations will need to be re done to fit my door jam configuration. Have our house being repainted next week so need this done ASAP.

Glass front sliding door not operating properly. It has become difficult to slide along the bottom guide rail, it becomes stuck and very hard to move and sometimes the door is difficult to lock. It looks like the door is not running parallel on the track. Photos attached.

Door needs replacing internal.

Supply and install 3/5 hinges to secure pantry door Supply and replace heat globe in ensuite (globes are $10-20) Preferable between 930-2pm.