Find a shower installation professional in Sydney Northern Beaches

We have had new taps installed in the shower & since then, the shower head keeps dripping (lots) unless we turn the taps really, really tightly.

Replace shower head, replace two bathroom taps Supplied by owner

I need to reroute the shower head. It will involve removing the tiles and re route the pluming to location indicated in the mockup. I’ll be removing the existing tiles and doing the demolition needed, but I need a licences plumber to the all the fitting and waterproofing. New tiles don’t need to be fitted as part of this job. The work needs Strata approval so I’ll need some details from the trades person. Budget is indicative only. As toughly draw on the last photo, there going to be a new wall install(red) and the plumbing(shower head and mixer (white))needs to be relocated on the wall. For this job please quote the waterproofing of the entire bathroom as the tiles will be removed and the rerouting of the plumbing.

Leaking shower head. Washers need replacing?

I need a Shower Head Fitted…asap, Narrabeen, Sydney, NSW, 2101

We’ve replaced our shower head and it looks like it needs to be sealed as there is a small leak.

Need new higher pressure shower head. Not sure if have to replace the whole system.

Need shower head re-installed as existing one has corroded and snapped off. Looking for a like for like 25$ dollar Bunnings or Reece replacement. No thrills just need something that works.

The shower head mechanism collapsed and need to be affix back in position

Hi there, I need help please to install a Well Verti Shower head. Attached are photos of my existing shower head and the filter I purchased. I’ve installed these before but this shower head I can’t seem to figure it out. Instructions from their website below: Easy Cartridge Replacement Step 1: Remove Plugs Start by removing the **white** and **blue** protective plugs from your shower filter. Step 2: Remove the Shower Filter Carefully disconnect the shower filter from your tap and set it aside. Step 3: Open and Replace Cartridge Twist the shower filter open and remove the old cartridge. Insert the new cartridge into the filter, ensuring it’s securely in place. Step 4: Close and Reinstall Close the filter and reattach it securely to your tap. Ensure all connections are tight for optimal performance.

Shower head leaking in tenants flat mostly likely requiring replacing worn washers.

The shower head in our shower has come loose and is hanging down. We’ve tried to twist it back upright but it won’t stay. Just need someone to come and take a look please :)

After someone to remove old shower head and replace with new one

We have a bathroom vanity that just needs installing in our main bathroom. We have a stud finder with AC and I can help you do the job if needed. The vanity is about 900mm wide by 720 high. This would involve finding the studs behind the bathroom wall, drilling through tiles as needed and installing the vanity cabinet. We would also like a shower head installed on our ensuite shower. We will supply the shower head and plumbers tape.

Fix leaking bath basin tap. Taps are new so should only require adjustment / fix. Replace shower head and adjust taps. Shower head provided. Request licensed plumber and evidence of this. Thanks

Install Kogan bolt-on bidet and Mondella shower head. I'd do it but I don't have the patience and tend to break things.

The shower head arm has started leaking. We have bought a new one. replacement needs to be done.

Need a handyman to replace shower head New one has been purchased

Install shower head in bathroom

1. Isolate water to house or fixture. Remove tap body, clean spindle, re seat brass bodies and flush water lines. Replace tap valve, grease stem and provide new O ring and fibre gasket to body. Re assemble tap, reinstate water supply and test on completion 2. Install Replacement shower head with new head