Find trusted mechanics in VIC

Install into a 2014 Kia cerato

I’m curious how much I could get someone to install a new double din head unit, and do the amplifier wiring in my Subaru.

I have a holden captiva 08 60th anniversary i need someone to connect the 8 pin plug that would usually go into the standard headunit which powers the top screen and ac/heater to my aftermarket Alpine ILX-W650E ( i do not have an adapter) also need standard amp disconnected so my almost complete two amp,4 speakers and sub install can be completed( all wiring in place ready to be plugged in.

head unit instal and buyyyyy

Need someone to replace my brake pads

Car window is broken. And I need someone to fix it asap.

Have everything you need, just needs to be installed

fit new head unit and reverse camera to 2011 subaru liberty wagon

I have the head unit with all the accessories, all you need to do is come and fix it into my Nissan Trail 2007

I have a Holden Cruze Equipe 2015. I previously had an 11inch screen installed but I don’t like it anymore as it doesn’t have Apple Car Play. I have purchased a new 9 inch screen and I need someone to install It

Have the pads, Lynbrook after 4pm or Brighton area during the day

HYUNDAI ACCENT 2016 NEEDS OIL AND FILTER CHANGE +BASIC SERVICING

I need to have the oil and filter changed on my car today at 4 p.m. at my home.

Open to quotes and flexible with time thanks

In middle of oil change but can’t get sump plug off as can’t find the correct socket Car is jacked up in garage, has Liquimoly engine flush in it so not drivable Car is Mercedes Benz 2014 A200

Looking for an experienced mechanic or qualified person to replace the brake pads on my 2022 Volkswagen Tiguan Allspace. I already have the new brake pads and grease ready to go. The job is purely installation – I just don’t have the required tools or the rear brake release equipment/technology to complete it myself. Details: * Vehicle: 2022 VW Tiguan Allspace * Parts supplied: Yes (brake pads + grease) * Work required: Remove old pads and install new ones (front and rear) * Note: Rear brakes require proper electronic release/reset

Currently have a stereo connected to an amplifier. However the wiring is extremely messy. Would like this cleaned up. The amplifier is sitting loose as well, so would like this mounted somewhere out of the way, such as under passenger seat etc. The cable tied wiring runs at the feet and up the centre of the passenger seat. Can take more pics if required. In addition, winch is not powering on so would like someone to look to see why, and ideally have this fixed if it can be. If it can't be, would be good to have someone there that can also install. Car is a Land Rover Discovery Series 1. Can also meet in East Doncaster if easier. Or drop car off if not too far from Abbotsford.

I have a 2008 530i BMW and I’m interested in having the unit installed

Head unit install and reverse camera

Need experienced mechanic service 2 cars – must follow exact oil change method. Oil and filters Supplied Description: Looking for someone to do an oil and filter service on 2 cars. This is not just a normal quick oil change. I want the job done exactly to a specific method step by step, so I need someone who is careful, patient, mechanically minded, and happy to follow instructions properly. Please only apply if you’re confident doing the below exactly as requested: Required oil change procedure: 1. Start with the engine completely cold. 2. Add about 1 litre / 1 quart of fresh oil to the existing oil as a pre-flush. 3. Start engine and let it idle for exactly 5 minutes. 4. Turn engine off and wait 10 minutes. 5. Then drive the car 10–15 minutes to full operating temperature. 6. Park on level ground, let it idle 2 more minutes, then drain the oil immediately while hot. 7. After the first drain, leave it for 30 minutes, then remove the drain plug again and do a second drain. 8. Fit new oil filter, but pre-fill the filter to about 60–70% with fresh oil first. 9. Apply a thin film of oil to the rubber gasket and hand tighten only. 10. Refill engine slowly with about 80% of oil capacity first. 11. Wait 5 minutes, then top up slowly in small amounts, checking the dipstick each time. 12. Final oil level should be around halfway between low and full, not overfilled. 13. After refilling, do not start the engine straight away. 14. Turn ignition on without starting, wait 10 seconds, then turn it off. 15. Repeat that 3 times. 16. Then start engine and let it idle for exactly 3 minutes without touching the accelerator. 17. Check for oil leaks around drain plug and filter. 18. Turn engine off, wait 2 minutes, then re-check oil level and top up if needed. Must Have • has experience servicing cars, or is very mechanically capable • has their own tools • works cleanly and carefully • is happy to follow this exact process, not their usual rushed method