Book a reliable car head unit installation service in Outer East Melbourne

I have already had the stereo installed but someone stole my head unit and I removed the sub. So needing a new head unit installed and the sub re connected. The car is a Jeep TJ Wrangler

supply and install head unit for carplay with reverse camera for mazda 2 2015

Install aftermarket head unit for Toyota Alphard

Hi, I’m looking for an experienced car audio installer to install a new Sony head unit and reverse camera into my 2012 Mazda 3 Neo (manual, standard factory stereo, non-Bose). Retaining steering wheel controls. I can supply the head unit, fascia kit, wiring harness and steering wheel control interface. Budget $180-220. Please quote your experience and previous installs. Thanks

I need someone to wire and install a new head unit in my car

Raypack gas spa heater head unit, sun damaged, hasn’t worked for a few years, we just bought the place. Need it replaced and wired up & tested.

Looking for an experienced auto electrician or car audio installer to fit a new Android CarPlay head unit in my Toyota Hiace (200 Series). The exiting head unit is Pioneer. The existing reverse camera must be connected and fully functional with the new unit. I already have the head unit, wiring harness, and accessories. Please quote if you have experience with Android head units and reverse camera wiring. Thank you!

I’m curious how much I could get someone to install a new double din head unit, and do the amplifier wiring in my Subaru.

Install a new head unit. In a C3 Corvette. -Trim the plastic fascia for the new head unit. (Must be confident to be able to do this so that it is neat and without causing damage. -Install the new head unit so that it is installed properly and secure. -Connect the new head unit harness to the car wiring, so that everything works (Must be confident that you’re able to figure out which cable does what) -Connect the speakers (2x 6” in the dash and 2x 6x9” in the back) -Wire up the electric arial so that it goes up and down when the radio is turn on/off. -Test everything to make sure there are no issues. Additional info: -The interior of the car is stripped, so all wiring is easily accessible. -The old original head unit was working, so the wiring should be ok. -I have access to the wiring diagram for the car. -I have installed a new electric aerial but I believe that the existing relay needs to be bypassed to connect it ( I have a video on what needs to be done, but I need someone that will be able to work out how to make the arial go up and down when the radio is turn on/off, if the instructions on the video doesn’t work) https://www.youtube.com/watch?v=X0OL5h4sDNo

Hi - I am looking at installing a head unit/radio & Front & Back hardwired dash cam for a Tiguan Pacific 2013 model. Details of the head unit: https://gtzone.com.au/products/volkswagen-tiguan-2008-2014-9-inch-wireless-carplay-android-auto-head-unit-navigation-bluetooth-wifi-head-unit?_pos=1&_psq=tiguan&_ss=e&_v=1.0 Details for the RGB to CVBS (RCA) AV Converter: https://gtzone.com.au/products/vw-camera-rgb-to-cvbs-rca-av-converter?_pos=1&_psq=converter&_ss=e&_v=1.0 Details for the Dash Cam (Hard Wired): Q200 | THINKWARE Australia GPS: GPSANT DASH CAM GPS ANTENNA | THINKWARE Australia Can you please quote? Need another quote for a second Dash Cam hard wiring install only for a Kia Cerato

New head unit is Sony xav-ax6000 and wanting to get it installed into my 2006 Prado gxl 120 series.

I need following work done on my 2008 Subaru Outback: - Radio Headunit installed - including reverse camera and front facing dash cam -LED Lightbar wiring harness installed and wired into high beam (I have harness and light bar mounting so just need electrical work done) Flexible with dates - evidence of completing previous similar work required.

Have purchased a 2011 kluger grande - have ordered a headunit, reverse cam etc - need someone to install tonight if possible https://www.cjindustriesaustralia.com/products/toyota-kluger-2008-2014-plug-play-head-unit-upgrade-kit-car-radio-with-wireless-wired-apple-carplay-android-auto?_pos=2&_sid=50d8f63a2&_ss=r

Head unit kits supplied including reverse cameras need to be installed in my 2007 Holden Rodeo/Isuzu and my mates 2008 Mitsubishi Triton and could be arranged for the same day. Although the Triton needs a surround/ fascia kit to be sourced, the installation could probably be done without that for the time being. (See images of the Rodeo dash, the new head unit is a straight swap of location and size. The image of the head unit is the one for the Triton which will be located in a higher central location)

Hi, looking for a quote for a double din head unit (Pioneer 6.8" DMHA5650BT) and reverse camera install for a 2009 Ford Ranger XT PK in Warranwood. I have all the gear including fascia/bracket and there is existing cabling for an old broken reverse camera. Thanks Simon

Remove existing head unit from 2013 Nissan Dualis and install a Kenwood carplay unit.

You tell me whether it’s possible my current Alpine iLX-W650E or if not, talk solutions with me. I’ll buy the fascia kit and wiring harness for steering wheel controls, and rear facing camera. My budget for you is purely labour.

Install Head unit and reverse camera on Mazda 2 DE. Have head unit just requiring installation.

Installation of a Pinnacle Head Unit (with model specific plastic moulded cover), Reverse Camera, and Front Camera in 2012 Ford Ranger. https://pinnaclecarradios.com.au/products/ford-ranger-2012-2015-px-wireless-carplay-headunit-kit?_pos=1&_sid=2b6159858&_ss=r

I need installation of Pioneer head unit model (DMHZ6350BT) in a 2007 Toyota Aurion. I have the head unit, I need installation done.