26 Retaining Walls Experts in Outer East Melbourne

I have 12 post holes that need to be dug in our backyard to support new retaining walls. Most need to be around 600mm deep to support a short 1m high wall as per the photos. The soil is clay-based and can be quite tough so a two-person posthole digger might be best or a one-person machine with a backup jack-hammer. Access is limited so heavier machinery (excavator) can't get to the area for digging unfortunately.

Backfill timber retaining wall

Install concrete sleepers into existing channel posts. 16 x sleepers. Heavy lifting, requires strong fit person with steel cap boots and gloves.

Hi just need outdoor fence a and retaining walls painted. I will provide paint. You need to bring in spray paint machine. Photos for sample areas. Please note actual area is more.. can't include all photos. But work can be done with spraying of 3-4hours.. Price fixed. ( if you save time its yours, and if you spend more price is same.)

See photos, a section of our retaining wall has fallen apart and needs replacing. About 4.4m long. Access is tricky as it runs beside a fence. The pipe in the photo needs removing (no idea what it is) and replaced with proper sleeper joiner post. We will provide sleepers and posts, quote request is for labour only please.

I would like a retaining wall under concrete patio

Building a concrete sleeper wall approx 25m long and 1m high Will need to drill post holes and concrete them in. It’s at an unoccupied house.

I am looking to get a C Channel welded to a H Channel for a retaining wall. The H Channel is already in the ground but the C Channel is 85cm long and will be welded to 85cm of the H Channel that is above ground. Access is good. I am flexible as to when this task is completed.

Installing 23m Treated Pine retaining wall with galvanised steel channel posts. Maximum 600mm high, All posts to be concreted into place. All sleepers are 75x200mm dimensions. Another 3m retaining wall of 1200mm high. Installing 2 sets of steps, 1200 mm wide, 550mm deep, 600mm over all drop over 2 steps. Raised seating, approximately 5m long @ 550mm deep, 400mm high. The material for all the above are available except for 1.5m3 of scoria stone, 15m of aerated pipe at inner base of wall length.

Install galvanised steel posts for retaining wall. Dig holes and install them in a level position

I need a landscaper or retaining wall installer to repair the defective retaining wall. Work date to be determine.

Need retaining wall built length of property

Hi I would like holes dug for a retaining wall to be built. Depth : 1200mm diametre: 300/350mm no. of holes: estimably 14 holes wide access to the back of house, ground has been already been prepared. markings will be ready for where the holes are needed.

Approximately 25 meters of walls of varying heights (200mm board width). Stain supplied. Will need 2 coats.

Install a 22m *600mm retaining wall with concrete sleepers.

Need a Bobcat + operator to backfill a retaining wall. Estimated 36m3. Quote to supply soil (if possible)

I need a handyman to repair the defective retaining wall.

Looking for someone to repair our brick retaining wall including sourcing a few new bricks that will be required

Concrete blockwork retaining wall to replace existing pine sleeper retaining wall. Blocks need to match in with existing concrete block stairs either side. Key tasks include: - Installation of 12.7m long x 0.6m high concrete blockwork retaining wall. - Connect retaining wall into existing steps at both ends for a consistent finish. - Retaining wall drainage, including modifications to connect into existing stormwater pipes. Note that removal of the existing sleeper retaining wall is not required; we can do this beforehand. Retaining wall is next to the driveway with good access. I'm not sure of cost so looking for quotes (hence the minimum $ in the ad).

Hi All, We constructed a small retaining wall. It's slightly 90mm over the boundary fence line. I plan to cut the posts in half and then move the timber boards to recess them between the posts. Just need someone to do it. Thanks.