Find a professional kitchen renovation contractor in QLD

Full kitchen assembly and installation

Hi. We have started with the installation of this kitchen but due to time constraints we need to move to another job. Installation of a toilet seat and a cabinet needed too

Looking for a reasonable quote to install a small kitchen. we have ordered the kitchen will just ned installation. Hoping that someone is available sooner than later. Location is Crestmead 4132

Need some kitchen renovations - remove cupboards and bench (Photo 1) - install/extend a current bench and install a new sink (Photo 2) - not replacing removed cabinets in Photo 1

We are looking for an experienced Ikea kitchen installer. Attached are the kitchen plans and dimensions. We have an Electrician and a Plumber lined up to fit the appliances.

Looking for an experienced kitchen installer to install a u shape polytec kitchen (approx 13 units total). CAD plans can be shared upon request. Cabinetry units are ready to go into production, I am just wanting to find the correct installer first. Depending on your labour quotes I can order the cabinetry pre-assembled

I need a Quote from a licensed electrician for my kitchen renovation. The job involves: Disconnecting the old kitchen electrics. Installing a new stove, oven, and rangehood. Replacing and installing new powerpoints, I'm flexible on the final locations and need advice on the best layout. Please let me know when you might be available to take a look. Thanks

Hi, Looking for a qualified electrician to install pendent light (photos attached). Its a 2 story house , there is around 1 ft (apx) gap in the attic, there are already down-lights installed in the kitchen so wiring is there, not sure if the same wiring can be used. Link for down lights - https://amzn.asia/d/4rRjSZ8 Also had few power cuts recently due to the dishwasher power point , not sure if the fault is in dishwasher or in the board, need this to be checked as well. Need a quote of air conditioner unit installation in one of the room. It ll be a brand new installation not a replacement.

Power Provisions for Oven (Wall), Fridge (Wall), Microwave (Wall), Rangehood (Wall), Dishwasher (Wall) and Two Above Bench Power Outlet/Sockets. Previous Kitchen Wiring still in ceiling/walls. Previous Kitchen has been removed and new kitchen is yet to be installed.

>> 1) Remove Old Kitchen >> 2) Remove existing Oven / Rangehood >> 3) Relocate Plumbing >> 4) Install New Kitchen Upper and Lower Cabinets, including Rangehood >> NOTE: Some cutting is required to make a few pieces >> 5) Connect LED Lights under each NEW upper cabinet >> 6) Install New 900mm Dual Fuel Oven with existing connections >> 7) Install Rangehood above oven with existing GPO

Old Kitchen Removed Plumbing Electrical Oven Installed New Kitchen Installed Splashback / Tiles Benchtops Kitchen Sink and Tap Under Cabinet LED lighting

It’s a Kabodle kitchen kitchen has all ready been removed just need someone to assemble the cabinets and install them

I was hopeful to get a quote to have an ikea kitchen installed? Our tradies were due to do it last week but let us down. We are currently demolishing the current kitchen cabinets everything is capped off, electricity, plumbing etc. old cabinets should be out by tomorrow at the latest. We are located in Northgate, the stone Maison needs the kitchen cabinets installed before he can measure everything and cut the stone to fit etc. Happy to send you through the plans etc. the actual kitchen itself is delivered and sitting in our garage ready to go… It is a small kitchen for a 2 bedroom townhouse all one level so no stairs

U shape kitchen install, no overhead cupboards. Approx 10lm Bench to be cut & some tall cupboards. No need for a plumber or electrician.

We are looking for a low-cost renovation that you would do for a rental property. Flatpack is fine for the cabinets, cheap stone tops, and splashbacks. We will supply all appliances and order the stone top but open to suggestions on where to buy the top from.

Seeking Assitance with IKEA Flat pack kitchen Installation.. ALL cabinet carcasses and draws constructed but need professional help to INSTALL and COMPLETE. Location CARRARA

I have finally received confirmation that my ordered bunnings kaboodle kitchen is ready. The flatpacks are due to arrive on site hopefully by the 30th May. I had a previous task posted which had expired due to waiting for this order. I can now proceed again looking for a local experienced installer. The work looks easy enough to do but this for my mother's house and I live in Sydney. Work required: Remove Existing Cabinets • There are 5 old falling apart cupboards and sink that needs to be removed, pictures provided. • Existing cabinets on the walls will stay. • Pantry will stay. Will need to carefully remove cupboard where it meets the pantry. Assemble Cabinets • Plenty of room in the under cover garage adjacent to the kitchen to assemble. Install Cabinets • Kaboodle FlatPacks. Measure and quote Images contain advise to installers. Can provide full PDF if needed. • No electrical work is required. Stove will be replaced later. Install Sink https://www.bunnings.com.au/blanco-stainless-steel-single-left-hand-bowl-sink_p0038519?srsltid=AfmBOoqyjHknfDJU8rpU37Tr1DvipjUjfU_Y83yIGquWvk7W76SgygAk • Measurement and Design PDF mentions SINK & ADDITIONAL CUTOUTS TO BE COMPLETED ON SITE BY INSTALLER/CUSTOMER. • Minimal plumbing work attaching the sink waste to the existing plumbing. Current sink is quite shallow and the new sink will be deeper. Straight forward job and should only require cutting the existing length of pipe connecting to the strap. I've attached pics of the kitchen, cupboards and under the sink. Also the Bunnings design kitchen measurements and new cabinets specs. Any questions let me know. Scott

Looking for a budget friendly quote to replace the old kitchen cabinets with new.

New bench sink and stove to install

Job Title: Finish Kitchen Installation – Caboodle (Bunnings) | Kickboards, Panels, Washing Machine Fit, Benchtop Description: Looking for an experienced and reliable installer to help finish off a partially completed Caboodle kitchen from Bunnings. The previous installer left the job half done, so I need someone confident and capable to see it through to completion. What needs to be done: • Fit and install kickboards/skirting along the base of the kitchen • Install cupboard and drawer fronts (including handles) • Cut a hole in a cupboard for washing machine hoses to run to the hot water system • Lift and place washing machine onto a base cupboard (with help) • Finish cupboard unit for the washing machine, including fitting doors • Glue/seal sink to benchtop (elasticised sealant or similar) • Install second benchtop once it arrives (coming from Bunnings) • Optionally: cut a few tiles – this may already be handled by a plasterer, but if you’re happy to include it, that’s a bonus • Vacuum and clean under existing cabinetry – access is available I’ll be on site the whole time to assist as needed and provide context. Happy to provide photos upon request or once you accept the task.