Find a professional garage door installer in North West Melbourne

Supply and install sectional garage door in monument colour with electric opener ,and remove the old one size 2500w ×2130 h

Garage door needs to be reset and reprogrammed to remote. Need someone who gets this stuff and has the patience to do it

I bumped my garage door and now its misaligned so neeed repair

I am looking to service my garage door. It is working fine, however occasionally makes noise while closing and opening.

Garage door, track wheel came off the track, see attached pictures.

Hinge of garage door is loose the door is sticking. Wooden door. I think the hinge is ok but the screws are rusty. A drawer in a dresser is stuck. A screw came out of the metal runner and the drawer will not close.

Garage door needs top hinge replaced. Drawer is stuck -has metal slides and has lost a screw so won’t close fully.

Need cabinets for storage in garage with sliding doors

Garage day has come off rails

Please provide a quote in your message. The renter has reported that the garage roller door is currently malfunctioning. The door needs to be manually pulled down, and when attempting to operate it via the remote control, the unit emits a continuous beeping sound without completing the closing function. This issue appears similar to one that was raised approximately five years ago, which your team previously attended to and resolved. Based on the current symptoms, it is likely a recurrence of a similar fault. From my initial review of the video provided, I believe the following may be contributing to the malfunction: Signal / Receiver Issue (most likely) The motor appears to have power; however, it may not be receiving the signal from the remote. Possible causes include: Disconnected or damaged antenna wire Fault with the receiver module (control box not communicating correctly) Interference from any added devices (e.g. WiFi/smart automation setup)

My garage door is randomly not opening. It is a Merlin MJ3 800 motor. Please refer to photo. I have pulled the cord disengaged: engaged it and sometimes it works and other times it won’t. I have noticed that there is a link broken on the chain, could this be causing it photo attached?

Garage door no longer responds to remote controls or wall panel control. Have tried resetting remotes & limits but still no response. Model is Steel line SD-800

The door seems to be off alignment and wouldn't close now.

Hi All My eco garage door chain not working. Motor is fine. Need someone to fix it

GARGE DOOR 2 SMALL REMOTE NEED IT

Looking for quote for a cladded aluminium batten garage door. Dimensions 2395 x 4360

Need somone for garage door servicing

I am looking for someone who can properly fix, realign my garage door. It's about a year old and had been adjusted 3x by the installer and still got to this point to have one of the roller come out of the rail. It's closing properly but obviously it's very noisy. I am looking for a professional fix , someone who is specialised in garage doors, can properly test it, label it with warranty and potentially maintain it on a yearly basis. It's a single garage. I will need an invoice.

Garage door needs to fixed. Garage door does not close properly. Hinges have come off the brick wall.

Hello, My garage motor on the single roller door has been playing up since I’ve moved in, I have two remote, one doesn’t work and is broken and the other one works randomly, every other week.. I can use the manual button on the motor, but it stops about 6 inches off the ground and can only go up with the power of the motor if I push the door up with it. I think it might need replacing but perhaps it has been set up wrong because it’s rolls down super quick but rolls up super slow (when it did work on its own without assistance)