Find professional pool gate repairs in NSW

I need our pool gate latch removed and fitted with a new one as the old one is cracked and broken

Our glass pool gate keeps catching - have tried adjusting but can’t seem to get it spot on. Need someone to assist and show me where I am going wrong!

Looking to install 2 pool gates ( photo attached)on both sides of house (next to the fence)

Currently the gate can not locked automatically as it is lower, I have to pull the gate up to click to the locker, so I need someone either reattach the locker or make the gate a bit higher to fix it.

1) Increase boundary wall height by approximately 600mm; 45m boundary wall, compliant with swimming pool boundary requirements 2) Make swimming pool gate self close and change direction of swing (minor work) 3) Relocate gate (minor work) 4). Demolish the Old barbecue (minor work)

We need our pool gate hinge and lock fixed or replaced. The pin has come out of the hinge so it doesn’t automatically close. The lock needs a new screw

2 pool gates need new hinges and pool gate locks - old locks and hinges need to be taken off and replaced with new ones Plus hang plastic pool sign

Adjust/ repair pool gate closing slowly lock not latching. 2 other gates need adjusting.

Need a pool gate or extra high lock for my front gate/fence Do not offer silly offers like $350 I am willing to pay $85 for a 30 min max job I have purchased the lock already

4 issues need to be resolved so the pool passes compliance testing. Issues are: 1) side poop gate (this is a standard backyard colourbond gate) gets caught on bamboo screening and doesn’t swing through its full arc of operation. This gate also does not self close and latch. 2) glass pool gates (x2) need to be adjusted so they properly self-close and latch. 3) glass pool gate (x1) is 10mm short of regulation height and needs to be raised. 4) glass pool gates (x2) need installation of 60 degree safety cap to top of each hinge.

A pool gate needs to be converted to a fence panel. This needs to be done so that it is just fixed to existing posts on either side. This is likely to require modifying pool fence brackets to hold the gate panel in place. Any other experienced solutions will be welcome.

2 pool gates need to be made compliant with safety regulations: - realigned - self-closing mechanism to be installed

2 tasks: - install door handle to existing door - change 2x pool gate hinges (I’ll also provide new hinges)

My stainless steel magnetic pool gate lock isn’t working

My pool gate isn’t properly aligned with my magnetic pool gate lock because the gate is drooping slightly. Inspected it and there’s a screw or two missing from the gate’s hinges and it just needs to be realigned for my pool gate lock to work again. You’ll need an electric drill for screwing, lock nuts/screws, etc.

My current pool safety latch/lock for my gate is acting up. Need someone to remove it and install a new one. I’ll purchase and have the new one ready.

Pool gate latch/lock needs to be replaced. New magna latch has already been purchased

**the gates are not for an actual Swimming pool, not required to meet the pool compliance ** You can get the products from the website below (they do click and collect and delivery to Sydney area), or if have similar or better, happy to discuss. https://www.fenceguru.com.au/ Pool gate installation X 2 1. Replace old timber door to black pool gate with 1.5 to 1.8m height(sample gate photo attached) the width is 101cm 2. Install the same gate between the house and retaining wall. The width is 110cm Disposal of old door, Material supply, labour and all other costs included.

My pool gate doesn’t shut properly when closing, you have to lift it a little to open and close properly. Just need a qualified fencer to fix.

I need the hinges on my pool gate tightened so the gate closes automatically as per pool compliance requirements