Find a local electronics repairer in Perth

I would like a quote to repair two paint chips on a white living room wall from boxes propped up against it, and sand and paint so no evidence of chips remain.

To repaint a ceiling cornice and maybe a few wall touch ups.

Yukka roots and stump to be removed from garden bed.

Hi! Need someone with a feel for these things to connect the old to the new. 65 inch Samsung television to audio technica turntable to an old but good Yamaha amplifier with Klipsch speakers….

2 x IKEA bench tops cut to the correct size. The pieces are 1860mm x 635mm and needs to be cut and joined to 1800mm x 900mm. This is the material: https://www.ikea.com/au/en/p/karlby-worktop-oak-veneer-50335190/

I’m looking to have 3 small olive tree stumps, and 3 old large (?)palm tree stumps ground out. Access to the large ones is down the side of the house through a gate, so equipment needs to fit through a gate

Replace 2 x Bathroom mixer taps (see pictures) I have the replacement taps already (same type as pictured), just requires removal of old taps and installation of new.

Remove tree stumps and Root systems. Need to make space for retaining wall.

To install the following - Toilet Bathroom cabinet - Taps etc Show head and taps

Need new washers on taps

Im at Walcott Laundromat and my car wont start please help me ow ☹️

I have 2 leaky taps fixed. Also I have an overflowing toilet cistern that needs fixing. And my other 2 toilet's flush mechanism not working well and needs looking into. I am happy to pay separately for any parts required.

Replace three stumps on weatherboard house. Two damaged jarrah stumps and one brick stack.

Re-hang 2 doors, install 4 door stops and a front door seal

1. Laundry tap set is leaking. May need pipe and resetting. 2. Install gas stove top. Stove top is purchased purchased 3. There is a gas leak behind the wall. Would need to remove oven, run a new gas pipe and reset oven and stove top after testing

8 taps in bathroom need washers? Hard to turn on/off and a couple dripping more

we have some chrome taps that need polishing back to brass. about 4 tap sets at the moment

Hi I bought an Ikea bed frame, it is a DYI product, For the last 2 steps need a powerful electric screw driver and someone who knows do it well can make it better. Maximum 5 mins task.

**REPOSTED as my SPECS CHANGED** I need 3 x bougainvillea stumps ground out please. Two are approx 30cm in diameter. One is approximately 20cm in diameter. Its a fairly narrow space. 60cm between the fence and the limestone block (see pics ) However we can remove fence by cutting it away. There is some old bitumen surrounding the stumps that will easily come away - crumbles. Retic is approx 54cm from the fence. I have tried to attach photos. They won't upload. Will try and add in comments Ideally I'd like this done Friday morning, but open to another time. Must be done by Sunday afternoon

Hi there! I’m looking for a qualified plumber or experienced handyman to swap over the mixer taps in my kitchen and laundry. Both mixers are already on site — I just need them removed and swapped. Details: Location: Inglewood Task: Swap existing kitchen and laundry mixer taps (1 each) Both mixers supplied Preferably completed today (Saturday, if possible) Please bring your own basic tools and any small fittings or seal tape you might need. Thanks!