Find a local console repairer in Inner South West Sydney

I need someone to build a collapsible bar cart - approximate dimensions are 1.5m (Length), 0.6m (Deep), 0.9m to 1m (height)

Job: I need an experienced plumber/handyman to fix several issues in my bathroom and kitchen: Toilet cistern not filling — water isn't flowing into the bowl, so flushing doesn't work well. Bathroom floor drain is draining very slowly. Balcony floor drain is completely blocked. Shower hot water mixer knob is loose and keeps falling off. Kitchen tap is loose and needs tightening/fixing. All work is in one apartment. Please bring your own tools and quote for parts if needed. Looking for someone reliable who can do the job quickly and properly. Location: Ba kstown NSW 2200 When: Flexible, as soon as possible Let me know your availability and rough quote. Thanks!

Looking for a painter for a small interior job in my apartment: 1. Sunroom ceiling, approx 2m x 2m - repaint white (currently light blue, smooth set, good condition) 2. Enclosed balcony ceiling, approx 4m x 2m - same, currently light blue, good condition 3. Minor touch-ups of small spots in the laundry Please supply paint and materials (white ceiling paint) - factor this into your quote. Both ceilings have a light fitting to cut in around, and there is exposed brick trim at the edges that needs a tidy line. Photos available. Access is easy.

I need the power point installed. Tile has been cut and the wall behind is gybrock.

Supply and install of kitchen and basin taps ( stainless steel ) and change the flood stops under the basin.

Outdoor steps for my front door are cracked and the steel bars are rusting. Need this repaired and then tiled over with new tiles. I want to use leftover bathroom floor tiles for this area - so I’m after cost of labour and materials for prep and laying of new tiles. Just need a basic flush square install - not worried about the overhanging lip design etc. whatever is most economical. Steps are 1.5m wide approx. 3 steps in total as pictured. Flexible on dates over the next month or so.

I have purchased a GPS and reverse camera that I need connected, the old one isn't working. The old one is connected to the radio unit, however, this is a whole new unit that will sit on the dash (photo attached). I need the reverse camera connected to the rear brake light and all cables concealed.

I need a toilet to be reseated and re siliconed. I also need a leaky shower tap to be replaced.

I’m after someone to place joining strips on my floor from where the flooring meets tiles or near a built in wardrobe. Roughly 8 needed in different sizes

We need installation of replacements for the following (all purchased already): - 1x Sink Taps + Spout - 1x Bath Taps + Spout - 1x Shower Taps + Showerhead Licensed plumbers only.

Supply and fit EZYFIX Chrome Classic Washing Machine Taps ($81.40 at Bunnings) to a house in Sans Souci If you have an alternate suggestion on the taps (for example if you have a brand new set in hand and recommend that instead) then please include details in offer. Happy to be flexible so long as the taps are good quality.

I need my two back door steps built. Ideally timber block boxed steps. It’s only two steps and timber will be provided. I am Open to some other way to build two steps if you have an idea

Job Title Wardrobe Dismantle & Plaster Patching (Upstairs) - DISPOSAL OPTIONAL Description Looking for a handy person or carpenter to completely dismantle a built-in wardrobe system from an upstairs bedroom and patch holes left in the drywall. Waste Disposal is OPTIONAL. Please provide a price breakdown in your offer: Base Price: Dismantle wardrobe, carry pieces downstairs, patch walls (leave materials stacked on-site). Add-on Price: Fully load and legally dispose of all materials offsite. The wardrobe is approx. 2.97m long. Scope of Work: Dismantle & Move On-Site: Carefully remove 3 floor-to-ceiling sliding mirror doors and their top/bottom tracks. Safely carry mirror panels down 1 flight of stairs; stack neatly on the ground floor. Strip out internal white melamine shelving, upright partition panels, and drawer runners. Note: Internal framing is nailed directly into walls/floor, not screwed. Please use a pry/crowbar to minimise drywall damage. Stack all timber neatly. Drywall Patching: Patch and flush-repair the rectangular drywall cutout/hole shown next to the skirting board in file. Patch any holes or surface tears left behind by framing nails. Optional Disposal: If selected, remove all timber, tracks, and mirror glass from the property. Requirements: Bring own tools (pry bars, track removal tools). Supply own plastering/drywall patching compounds. Must be physically capable of safely moving large mirror panels down stairs.

Need these 2 driveway ramps drilled screwed into the ground. 4-6 screws each. So it stays put

Looking for an experienced handyman/builder to install 5 glassless dance mirror panels onto a wall in a home studio space. Each panel measures 200cm x 120cm, and I’d like them installed side-by-side to create a seamless mirror wall. Product link (for reference): https://dance-floor.com.au/product/portable-dance-mirror-180cm-x-120cm/ What’s included: - Bolts and brackets - Mini spirit level - Fabric gloves for handling mirrors - Instructions (attached) What you’ll need to bring: - Drill and appropriate tools - Experience mounting large panels securely to walls. Key Requirements (important) - Strong attention to detail is a must - Panels must be installed flush and tightly aligned (no visible gaps between mirrors) - Must ensure level, straight, and secure installation - Careful handling to avoid damage during install

Hi! I hate assembling flat-pack furniture but apparently some of you really like it? I just moved into a new apartment in Campsie and would love someone to come round and reassemble my IKEA Brusali Luroy double bed. You would need to bring all of the required tools. I was hoping to have the bed assembled today (Sat 18 April) before 6pm. Sorry for the short notice! Thanks!

Terracotta roof tiles need repointing. Gutters are sagging on two sides. New downpipes potentially needed - advice on this needed. Colorbond barge caps to 3 gables. Please include to supply all materials and access equipment for the task.

Hi, after a recent repair, the laundry taps are all messed up. The hot water tap wouldn't stop the water, it keeps on running. I have to stop the main one for all hot water to stop. The cold one as well also has some leaks. I would appreciate some urgent help to fix the taps today.

Looking for a licensed plumber to install aerators on 4 taps and provide a water efficiency compliance certificate for a rental property in East Hills NSW. A recent water efficiency test found the following taps above the 9L/min requirement: 1st floor ensuite mixer tap – 12 L/min 1st floor bathroom mixer tap – 12 L/min Ground floor WC mixer tap – 15 L/min Ground floor ensuite mixer tap – 14 L/min All showers and the kitchen tap already comply, so only these 4 taps need aerators installed and re-tested. Job includes: Supply/install aerators or flow restrictors Ensure taps are ≤9 L/min Provide a water efficiency report / certificate Location: East Hills NSW Should be a quick job. Please confirm you can issue the water efficiency certificate. Can provide previous test report proving only these 4 taps are not compliant.

I need a plumber to change 3 basin taps and 3 shower taps and 3 basin wastes in my parents house.