Find local power point installers in WA

Need. A power point installed for exhaust fan in the attic. Junction box 1 meters away from exhaust fan. Good access in the attic. Exhaust already instaalled. Need a power point connected to light switch in the shower. Exhaust should turn on with the light. You bring all equipment required including 3 core cable, power point e.t.c

Need to install 2x Power Points for TV’s. Both have power source near by. Wall is double brick. Access to roof if required.

Electrical work: hard wire new oven and fix a range hood power point and refit rangehood

Outside: change single GPO to duel. Kitchen/Launday: 1 new GPO in laundry, 1 new GPO on benchtop, 2 new downlights over benchtop. Bathroom: 1 new GPO, change LED downlight to heated light. Ensuite: 1 new GPO, change LED downlight to heated light. Master: 1 new GPO We can supply new outlets and lights.

2 -3 new power points needed for the new range hood, TV and potentially bathroom. Offers per power ponit pls.

Hi ,change of plans since last post , needing 3 power points and 2 fluro lights in a garage

Hi Iam setting up a home workshop and I need some 3phase RCDS and power points installed I have had all the power points mounted and cables ran to the sub board In total I need 3x 20amp 3ph power points wired up 3x 10amp power points wired up and 1x 15amp power point wired up I will need a main switch put in to the switch board to run power in to the workshops sub board and then RCDS for the power points in the sub board

Install 2 power points 1 kitchen 1 outdoor. Thinking can piggy back off existing outlets...

Need a 15 amp power point for a pool heater.

Install 3/4 power points and bathroom ceiling fan.

Wanting to replace 2 X Power Point Faceplates in the garage with ones I've bought and received from Amazon. Please see attached images to see the current setup + new faceplates to be installed.

Remove 2x security lights 1x PowerPoint 1x light fixture 1x aircon point Eaves are being removed and then will need to be replaced when eaves are reinstalled

- Outdoor, weather protected power point to be installed for 10 amp spa. Please bring your license with you for sighting

Power switch for electric stove has stopped switching on, I think its just the switch that needs repairing or possibly replacing

PowerPoint replacement it has stopped working Location coongan st Greenmount

Professional accredited electricians only. We require another power point in the garage on the side I park my car (internal wall) so I can charge my car. There is another power point on the inside of the house close by where I would like the power point on the other side of the wall in the garage - we are unsure if this helps the installation or causes complications. Power point must be suitable for EV charging (AC charging) but open to recommendations if you have other ideas that are suitable. We would also like another light installed in the garage where the internal door is, as the placement of the existing lights when the house was built 3 years ago was not done well. Ideally we’d like this hooked up to the same light switch we have now that turns the other 2 lights on/off. PLEASE provide a quote for both seperate jobs (power point installation + light) so we can assess whether we’d like to do both jobs or just the power point installation alone which is priority. Victoria Park 6100, flexible on time.

We currently have an old hardwired oven and are hoping to replace this with a new 10A plug/ lead oven. We dont need the old oven taken away, just need new power point/socket installed to rear of empty oven recess that will allow installation of a suitable new 10A plug oven when it arrives. New oven hasn't been purchased yet as we first want to determine whether conversion from mains wiring to 10A plug socket power for oven is easy/ possible to do or not. Note: please excuse the mouse poop shown in the photos, this was discovered when we pulled out the old oven and will be cleaned up before any electrical works take place.

Need to move PowerPoint about 15cm to the right so it fits in a new cupboard. Double brick wall. 2 story Town house. Please read screenshot in photos.

One outdoor power point install required. Indoor power point on exact other side. Single brick, single story house. Requires an RCD 30mA

Licensed electrician to install additional light and power points in a less than 2-year old house. Single-storey house Power and light fittings supplied by owner. 3 x new light points and 3 x power plates.