Find local power point installers in Sydney

Install new power point in existing room that has one power point already installed on another wall. House is single story, double brick.

Instal new power point on side of bench. There is already one on the other side so shouldn’t be too much work When I added pics all messages were deleted. Pls msg again

Install 2 additional power points, move down one existing. Pre wire 2 led strip lights

Looking to modernise my apartment in Erskineville by replacing the existing fittings with Clipsal Iconic products to give the place a fresher, more contemporary feel. Work required: * Double power points ×10 * Single power point ×1 (would ideally like this upgraded to a double power point if possible) * Telephone sockets ×2 * TV connection ×1 * Light switches ×4 * Combined TV/telephone outlet ×1 Photos provide an indication of what’s required, although I could only some photos so not every outlet is shown. Timing: Looking for someone to visit me mid to late morning or around midday on Wednesday 24 June. Materials: Please quote for labour only. I’m happy for the Clipsal Iconic plates and accessories to be supplied and charged separately at cost price. Please let me know if you require any additional information. Thanks.

Looking for an experienced handyman to repair and tidy the wall around 5 existing power points in an older house. The power points are working, however an electrician has advised that the wall/plaster around some of them is crumbling, which is causing the outlets to pull away from the wall. Tasks include: Remove loose or damaged plaster around power points Fill and repair damaged areas Rebuild and strengthen wall surface around outlets where required Sand smooth and make paint-ready Ensure power points can sit neatly and securely against the wall once repaired General tidy-up of surrounding wall finish No electrical work is required. Please bring basic patching materials and tools.

Install 3 x power points. Registered electrician only. Third floor of art deco apartment block. Photos are preferred socket placement.

Hi, I need a licensed electrician to add 5 extra power points in my apartment. I’ve attached a floor plan: existing power points are marked in blue, and the spots where I’d like new ones added are marked in red, if possible. They’re in a few different rooms, including bathrooms. There are existing power points close to most of the new locations, so I’m hoping it may be possible to connect from those, but you’d need to inspect and confirm. Most of the walls are probably plasterboard, but the bathrooms have tiled walls, so I’m looking for the neatest possible approach. The work needs to be done cleanly, with no damage to the walls or bathroom tiles if possible. I’m looking for a quote and advice on the best way to do this. Please only respond if you are a licensed electrician. Please include your NSW electrical licence number in your offer and confirm that you can provide a Certificate of Compliance for Electrical Work (CCEW) after completion.

I’m hoping to get a new power point installed in a storage room. There’s not a point directly on the other side of the wall, but somewhat close. I’ve marked some ideas for placement in red. The other room in the photos in the cupboard to the immediate left of the storage room.

Supply and replace 2 x old power points (pictured) with standard white 2 switch power points. Please provide all inclusive offer

Looking to install a power point on the wall in the picture, in the middle of the two mirrors, please only licensed electricians. Can either do Monday 25th of May or Saturday 30th of May.

Hi, I have a double power point where one socket works perfectly, but the other socket is dead. It likely needs a quick inspection and potentially a replacement unit if the internal mechanism has failed. Could you please provide an upfront standard repair rates for this type of issue?

Need a licensed electrician to install a weatherproof outdoor power point on my apartment balcony. The new outlet would be installed underneath the existing AC unit area. There is already an internal powerpoint located directly on the inside wall, which is connected to the existing AC circuit, so I believe the new outlet can likely be run from there. Job should include: Supply and installation of outdoor weatherproof powerpoint Safe connection to existing circuit Testing and compliance The job appears relatively straightforward with easy access and should take approximately 1–2 hours. Please only respond if you are a licensed electrician and can provide licence details if required.

I need an electrical socket / power point for the cupboard under my stairs as I’ll be converting it to a home office

I need a person to purchase 2 glass double power points and install them in my kitchen- there are already power points there but want to update them - I have attached a picture of the power points I would like and it must be slim line

Electrician to supply and install new internal small unit switchboard in kitchen also to disconnect hardwired oven and hot water system. Connect hardwired new Oven, cook top, and install new power point. All in kitchen with easy access by way of lift from parking area in Rushcutters Bay.

Splitting and moving a 3 way light switch from behind a bedroom door to 1 switch to the correct side of the bedroom door, and 2 switches to outside the room (see pictures). Also, moving a power point to behind the tv (see pictures). It's a single story apartment on level 4 of 6. Walls are gyprock with metal studs.

Looking for a licensed electrician to replace a faulty power point connecting to my fridge. The outlet works for low-power devices (e.g. phone charger)It does not work for higher load appliances like a kettle or fridge.Other outlets in the apartment are working fine. Fridge works when plugged into a different outlet Seems like a loose connection or faulty socket that needs repair or replacement. Location: Rosebery, Sydney Timing: ASAP Parking: Available nearby

I need to fit a double power point to the wall of the lounge room, I have removed the skirting board so all you will need to do is drill through the masonry wall and connect to the wiring shown in the photo on the exterior side of the wall, I will supply the power point and connectors.

We are moving floors this weekend, we require three power points to be set up. There seems to be covered over access points. We need a licensed electrician. I’ll be available to allow access thisSunday and next Monday if easier as well.