Find local power point installers in Inner South West Sydney

The RCD labelled “Protected Power” (C20, 30mA) trips the instant I switch it on, so all power points are dead. Lighting circuit is fine. Cause is known: insecticide spray went into one power point and the tripping started immediately after. The RCD has been off since and I haven’t touched the outlet. What I need: the affected outlet inspected and replaced, and the circuit tested.

I have 3 power points that need replacing

I want to extend power points in couple of places at home. And I also want to get the garage checked as there is no power in there so probably something wrong from the box? Might also take this opportunity to replace some of the existing points with the newer ones that had USB charging in built.

I have an external power point that I need installed by a licenced electrician. I will supply the materials (external weatherproof power point)

Install single power point to a 15a to charge EV car

I need to replace 2 power points and 2 light switches. 1 set is in the bathroom on a tile and the other is in bedroom. I have the replacement parts. Just need to replace them and fit them on the wall/tiles

I am looking for a fully licensed NSW electrician to supply and install one new extra power point in a bathroom at a single story house in Padstow and able to provide CCEW. Just take extra care of the wall tiles.

Installation of 20A powerpoint needed to plug in a dual fuel oven. 40A junction box has already been installed by previous owners I believe so powerpoint just needs to be wired

Need a licensed electrician to replace 3 light switches, 3 double power points and 1 bathroom batten light fitting. I have already purchased all the replacement fittings. Please install them and test that everything is working properly. Photos attached

I need a power point installed in my wall

Description: Looking for a qualified handyman/electrician to: * Securely wall mount a 50-inch TV. * Install a new power point/switch board behind or near the TV for a neat setup. * Concrete wall and connection borrowing can be done from nearby balcony light switch. Supplies/materials are not included and will be reimbursed or purchased as advised. * Please bring your own tools. * Experience with TV wall mounting and electrical work is required. * Please provide a quote for labour only.

Test and Fix power point back into brick wall as it has popped out of the wall

Hi, I’ve managed to mount an LED light using an extension lead form existing PowerPoint to keep my garage door opener running, but I think installing a power point would look less messy. Could do it myself, but it would void the warranty & my insurance 😅, hence, need a licensed electrician to carry out the installation. A external mount is fine; no need to chase the wall. Could you please give me your best quote and let me know your availability? Thanks!

I need a licensed electrician to replace 10 power points and 10 light switches throughout my home in Kogarah. This is a straightforward like-for-like swap - same locations, no new wiring runs. I’ll purchase the hardware and will be ready on the day. The job: - 10 double GPOs - swap only - 10 light switches - swap only - All items in the one property, one visit Requirements: - Licensed electrician only The date of this task is flexible and will be at the tail end of a kitchen renovation, looking around w/c 20th July.

I need to install 4 PowerPoints in different parts of the house. Quote should include both materials and labour. Pictures show where I want new points in red and where the existing points are in blue. We are in a 2 level duplex.

Install a power point on the outside of a double brick wall of 1 storey house. Need a licensed electrician. better speak mandarin. No power point on the direct opposite side (inside) of the wall but has one around 1 m away (see photo).

I need a power point replaced at my home in wiley park. I can get the replacement parts, you have to replace it.

I need two power points replaced in my unit. One is in the kitchen, where I accidentally broke the mounting plate/holder while unplugging a toaster. See first two photos. The second is an outdoor power point with a loose plastic housing, so I would like the entire unit replaced. See last photo. I will purchase the replacement power points from Bunnings, so I only require installation. There is no urgency, and I am flexible with timing. Could you please provide me with a quote for the work? Thank you.

Need a power point installed in my garage in an apartment building. Line will need to be brought from a switchboard which is about 10-15m away. Need an electrician with certain experience in doing a very clean a finish job.

Make the household rent-ready and the studio functional as soon as possible. Scope includes, primarily, replacing the dimmer light switch in the upstairs middle room to a normal light switch. Secondarily, re-installing light switches in the studio and wall power points. This job is focused on urgent, simple works only.